Sterngold | Supplies & Equipment –
InstaTemp®, SternVantage
Temporary Crown & Bridge
INSTATEMP ® MAX Bis-Acryl Composite for Temporary Crowns, Bridges, Inlays and Onlays
InstaTemp Max **
Rubbery phase [min] Remove frommouth
2:00 - 3:00
3:00 7:00
End of cure (incl. mixing) [min] Diam tensile strength [MPa] Compressive strength [MPa] Water absorption [µ/mm3] Barcol hardness (24 h, wet)
36
220
10 35
Heat development during setting [ºF]
100
Shades available
A1, A2, A3.5, B1, Bleach
SettingTime onModel: Rubbery phase [min] Remove frommodel [min] End of cure (incl. mixing) [min]
2:00 - 3:00
3:00 7:00
To eliminate polishing, purchase SternVantage Varnish LC.
Indications • Temporary crowns and bridges • Long term temporaries • Provisional inlays, onlays, and veneers Advantages • Exceptional adaptation and fit • Low curing temperature - 100˚F • Low polymerization shrinkage – less than 1.0% • Self curing • Smooth surface after polishing • Good biocompatibility • Easily repaired with itself or with any other composite • Contains nomethyl methacrylate • Odorless, tasteless, and no allergic reactions • Outstanding color stability • Five Shades A1*, A2*, A3.5*, B1*, Bleach*
InstaTempMax Refills 1 cartridge @ 76g paste, 15 mixing tips A1
Advantages of the Automix System • No handmixing necessary • Can be applied directly into the impression/ matrix • Homogeneous material quality • No air bubbles
220216 220217 220219 220218 220222
A2
A3.5
B1
Bleach
• Autoclavable dispensing guns • Small mixing tips reduce waste
MixingTips
220220
45 pieces
* Corresponds toVita-colors, RegisteredTrademark of Vita Zahnfabrik
Dispensing Gun
220221
4:1 ratio
** Detailed instructions included with products.
SternVantage ® Varnish LC
220232
5 ml bottle
STERNVANTAGE ® VARNISH LC Unfilled light cure resin which produces a high gloss, hard surface with no polishing necessary
SternVantage Varnish LC is a light cure one-component surface coating material that cures without a smear layer caused by oxygen inhibition. It has been developed especially for caseswhere the surface of acrylatematerials after polymerization exhibits an undesired or intolerable smear layer. It can also be used in cases where increased surface hardness is desirable, or where the oral environment must be protected from elution of monomers out of freshly polymerized materials. Treatment of polymerized composite surfaces, custom trays or temporary crowns and bridges with Varnish LC yields a hard, high gloss, solvent and stain resistant, ultra dry finish with a smooth surface.
Plaque formation and deposition of calculus is minimized. Varnish LC is cured with a common dental halogen light unit or in an UV or stroboscopic light unit.
• Solvent and stain resistant • Ultra dry finish with a smooth surface
SternVantage ® Varnish LC
220232
5ml bottle
6
SUPPLIES & EQUIPMENT
WWW.STERNGOLD.COM
Made with FlippingBook - professional solution for displaying marketing and sales documents online