Field Operation
SPEEDTILLER START UP TIPS
THIS IS A GUIDE ONLY AND MUST BE READ IN CONJUNCTION WITH INSTRUCTION MANUAL.
1. DEPTH CONTROL • Start by setting roller 40mm higher than discs on level service. • Ensure wing roller heights are set the same. (Folding wing models only).
Tracking Left
Tracking Right
Front disc too high
Front disc too low
Figure : 4.1 Tracking Adjustments.
2. TILT ADJUSTMENT (SETTING TO REDUCE SIDEWAYS TRACKING) • Start with front disc 20mm higher than back discs. • Follow diagram for tilt settings.
• To adjust, turn front adjuster and lock. 3. FRONT LATERAL DISC POSITIONING • Front lateral disc positioning is factory set for standard operating conditions. • If adjustment is needed follow 4. FIELD OPERATION - Lateral Front Disc Gang Positioning . 4. WING DOWN PRESSURE • It is recommended to place wing fold circuit (YELLOW) in float mode. • Apply wing down pressure only where soil is hard and dry See 4. FIELD OPERATION - Tracking Adjustments 5. SPEED RANGE • 8-15km/hr. (5.9mph). • Greater activity occurs at higher speeds. • Slow down in rough terrain (such as rocky country). 6. HEADLANDS/TURNING • Always slightly raise machine when performing headlands (turning at end of run) etc. • For 3 Point Linkage machines, raise machine with Tractor Linkage Height Adjustment so discs and rollers are not in contact with ground. • For Trailing and Powerflex machines, raise machine with wheels so discs and rollers are just out of contact with ground. 7. ROAD TRAVEL SPEED LIMIT • 32kmh (20mph).
4.2
2915P Speedtiller Powerflex
OPERATOR & SAFETY MANUAL
2915P Op & safety manual.indb 2
6/02/2023 9:31:17 AM
Made with FlippingBook - Online Brochure Maker