Fastening
If an incorrect value is entered, an error statement containing the minimum to maximum values and an X mark will appear on the left side of the cell. It must be canceled by re-entering values in the range or pressing ESC.
A total of 15 tightening presets are supported, each of which can be configured as Torque, Speed, Min/Max angle, etc. Refer to the
Torque graph and enter the desired setting value. (TC/AM: Torque control, AC/TM: Angle control)
Fastening Setting Parameters
Each individual tool encompasses these parameters that can be configured for each preset. Parameter Type Description
Type
-
Select the Torque control or Angle control mode
Target torque (unit)
Torque
Sets the target torque
Max torque (unit)
Angle
Sets the maximum torque
Torque limit (%)
Torque
Determine how much % limit you want to put on Target torque.
Min torque (unit)
Angle
Sets the minimum torque
Target angle (degree)
Angle
Sets the target angle
Min angle (degree)
Torque
Sets the minimum angle
Max angle (degree)
Torque
Sets the maximum angle
Measure the angle from when the target torque reaches a certain % value. ex) Target torque: 100.00/Snug torque: Measure the angle when the torque reaches 90.00 when set to 90.00. Sets the target speed. If the Auto speed option is enabled, it is automatically set and cannot be changed manually.
Snug torque (unit)
Torque
Target speed (rpm)
-
Angle for free speed (degree)
-
The angle at which Free Speed will be used.
Free speed (rpm)
-
The speed to reach Angle for free speed.
Soft start (ms)
-
Set the time to reach the target speed.
Set the point where the Target speed decelerates, and Torque rises. At this point, it is usually determined that the head of the screw touches the fastener. However, this setting value is also a factor in the increase in tightening time for Soft joints.
Seating point torque (%)
-
Torque rising time (ms)
-
Setting the time to rise from sitting point torque to target torque.
Setting the speed from the setting point torque to the completion of the tightening.
Ramp-up speed (rpm)
Torque compensation (%)
Sets the Torque compensation value.
MountzCom III User Manual
20
Made with FlippingBook Annual report maker