Graph Data
Data
Description
Index
The index of the data.
Time
The time the data was received.
Channel 1
The type of chart on channel 1 when the data is generated.
Channel 2
The type of chart on channel 2 when the data is generated.
Sampling
Graph data sampling interval when data occurs.
Fastening time
Tightening time.
Target torque
Setting Torque when data is generated.
Torque
Converted torque when data occurs.
Speed
Target speed by parameter
Angle 1
Angle from motor start to screw seating point
Angle 2
Angle from screw seating point to the end
Snug angle
Angle from snug torque to the end
Error code
Error code when data is generated
Remain screw
Number of screws left when data occurred
Event data types Other: Others Fastening Complete: Fastening OK Fastening NG: Fastening NG Direction Change: Forward / Reverse change Preset Change: Preset change Alarm Reset: Alarm reset Error Without NG: Error without fastening NG Barcode: Enter Barcode (EPT only) Screw – 1: Cancel previous tightening (EPT only)
Status
Seating torque
torque at the time of sitting on the ECT+
Clamp torque
Result torque for value of clamp torque set on ECT+
Prevailing torque
Average torque in angle interval set on ECT+
Compensation torque
Final torque when using Advanced mode on ECT+
MountzCom III User Manual
38
Made with FlippingBook Annual report maker