INSTALLATION INSTRUCTIONS
Wall Studs
Wall Studs
Wall Studs
A
A
A
2 x 6 Cut to length of the wall cutout
2 x 6 Cut to length of the wall cutout
2 x 6 Cut to length of the wall cutout
Wall Studs
Wall Studs
Wall Studs
A
A
A
1. Draw a horizontal line at the desired mounting height. Draw a second line parallel to and 6” below the first. The line length and subsequent cutout in Step 2 should be the width of the cabinet(s) being installed plus the distance to the next wall stud on each side.
2. Using the lines from Step 1 as a guide, cutout and remove the wall covering to expose the wall studs.
3. Cut a 2 x 6 the length of the cutout. Place it in the cutout against the wall studs and mark the top and bottom on each stud. Using a circular saw with the blade depth set at 1 1/2” + the wall covering thickness, make cuts at the top and bottom marks and additional cuts as required to remove the material inside the notch. Clean out any excess material with a wood chisel. 2 x 6 Cut to length of the wall cutout 2 x 6 Cut to length of the wall cutout
2 x 6 Cut to length of the wall cutout
Install 3" Washer Head Screws in all available mounting bracket holes.
Install 3" Wa Screws in all mounting bra
Install 3" Washer Head Screws in all available mounting bracket holes.
Wall Covering removed in Step 2
Wall Covering removed in Step 2
Wall Covering removed in Step 2
2 x 6
2 x 6
2 x 6
Install 3" Washer Head Screws in all available mounting bracket holes.
Install 3" Washer Head Screws in all available mounting bracket holes.
Install 3" Was Screws in all mounting bra
A
A
A
Optional Ledger Strip
Optional Ledger Strip
Optional Ledger Strip
Wall Covering removed in Step 2
Wall Covering removed in Step 2
Wall Covering removed in Step 2
2 x 6
2 x 6
2 x 6
A
A
A
Optional Ledger Strip
Optional Ledger Strip
Optional Ledger Strip
Wall Studs
A
2 x 6 Cut to length of the wall cutout
4. Place the 2 x 6 in the notched area of the wall studs and secure with construction adhesive and a minimum of two 3” screws (not included) to each stud. Once secured, the 2 x 6 must be flush with the face of the studs.
6. (Optional) For additional support and to aid in installation an option Ledger Strip can be installed at the bottom cabinet height. The Ledger Strip should be cut to a length such that it is not visible when the cabinet(s) is installed. Secure to all available wall studs using 2 1/2” screws (not provided).
5. Replace and secure the section of wall covering removed in Step 2.
Install 3" Washer Head Screws in all available mounting bracket holes.
7. Place the cabinet on top of the Ledger Strip in the desired location with the back against the wall. Check that the cabinet is level & plum and secure to the wall by installing 3” washer head screws (not provided) in all available holes in the mounting brackets. DO NOT USE POWER TOOLS TO LEVEL THE CABINET. 2 x 6 Wall Covering removed in Step 2
A
Optional Ledger Strip
6.1–4
Made with FlippingBook Online document maker