Web Interface – Configuration
Port LED Indication mode C: Green: Solid=Full Duplex Off=No link Orange: Solid=Half Duplex, Blink: Collisions
Port LED Indication mode B: Green: Solid = Link, Blink=Activity Orange: Solid = Port disabled by management, Blink = Errors received
Port LED Indication mode A: Power save mode - LEDs are off.
4.6.3
LEDs Intensity The LEDs power consumption can be reduced by lowering the LEDs intensity. LEDs intensity could for example be lowered during night time, or they could be turn completely off. It is possible to configure 24 different hours of the day, at where the LEDs intensity should be set The LED intensity timer has the following configurable parameters: Start Time The time at which the LEDs intensity shall be set to the corresponding intensity. End Time The time at which the LEDs intensity shall be set to a new intensity. If no intensity is specified for the next hour, the intensity is set to default intensity. Intensity Set or show the LEDs intensity (100% = Full power, 0% = LED off, Default = 100%) Maintenance During maintenance of the switch (e.g. adding or moving users), a network administrator might want to have full LED intensity. Therefore, it is possible to specify that the LEDs shall use full intensity at specific period of time. Maintenance Time is the number of seconds that the LEDs will have full intensity after either a port has changed link state, or the LED pushbutton has been pushed. On Time at Link Change Set or show the number of seconds for LEDs to be at full intensity during link status change. On at Errors
4.6.4
Set the LEDs to full intensity on errors
LEDs intensity not affected by errors (Default: this is the default)
Confidential
User Guide: CE Services
Page 141
Made with FlippingBook interactive PDF creator