IGMP Snooping Enabled Set or show the per VLAN IGMP Snooping status.
Enable the Global IGMP Snooping
Disable the Global IGMP Snooping (This is the default.) Up to 32 VLANs can be selected for IGMP Snooping.
Querier Election
Enable this entry to join IGMP Querier election in the VLAN (This is the default.) Disable this entry to act as an IGMP Non-Querier Querier election is used to dedicate the Querier. This is the only Querier to which the sends Query messages, on a particular link. Querier election rule determines that IGMP Querier or MLD Querier with the lowest IPv4/IPv6 address wins the election. Querier Address Set or show the IPv4 address as source address used in IP header for IGMP IGMP Querier election. When the Querier address is not set, the system uses IPv4 management address of the IP interface associated with this VLAN. When the IPv4 management address is not set, system uses the first available IPv4 management address. Otherwise, system uses a pre-defined value. By default, this value will be 192.0.2.1. This column displays the switch port number of the logical STP port.
STP Enabled Set or show the STP status for this switch port.
STP is enabled on this switch port (This is the default.)
STP is disabled on this switch port
4.31.2
IGMP Snooping VLAN Configuration Buttons Refresh: Refreshes the displayed table starting from the “VLAN” input fields.
Back Arrows (
): Updates the table starting from the first entry in the VLAN
Table, i.e. the entry with the lowest VLAN ID.
Forward Arrows (
): Updates the table, starting with the entry after the last
entry currently displayed.
Add a New IGMP VLAN:
Click to add new IGMP VLAN. Specify the VID and configure the new entry. After creation of the new entry the user must click “Save”. The specific IGMP VLAN starts working after the corresponding static VLAN is also created.
SMB - CLI UM
Rev: 1.1
Page 151 of 275
www.amphenol-socapex.com
Tel : +33(0)4.50.89.28.00
Made with FlippingBook interactive PDF creator