Note:
If the default CoS has been dynamically changed, then the actual default CoS is shown in parentheses after the configured default CoS.
DPL Set or show the default Drop Precedence Level.
Every incoming frame is classified to a Drop Precedence Level (DP level), which is used throughout the device for providing congestion control guarantees to the frame according to what was configured for that specific DP level. A DP level of 0 (zero) corresponds to ‘Committed’ (Green) frames and a DP level of 1 or higher corresponds to ‘Discard Eligible’ (Yellow) frames. The classified DPL can be overruled by a QCL (QoS Control List) entry. PCP Set or show the default PCP value. All frames are classified to a PCP value. PCP is an acronym for Priority Code Point. It is a 3-bit field storing the priority level for the 802.1Q frame. It is also known as User Priority. A PCP of 0 (zero) has the lowest priority. If the port is VLAN aware and the frame is tagged, then the frame is classified to the PCP value in the tag. Otherwise the frame is classified to the default PCP value. DEI Set or show the default DEI value. All frames are classified to a DEI value. DEI is an acronym for Drop Eligible Indicator. It is a 1-bit field in the VLAN tag: 1: drop eligible 0: not drop eligible (default) If the port is VLAN aware and the frame is tagged, then the frame is classified to the DEI value in the tag. Otherwise the frame is classified to the default DEI value. Address Mode The IP/MAC address mode specifying whether the QCL (QoS Control List) classification must be based on source (SMAC/SIP) or destination (DMAC/DIP) addresses on this port. The allowed values are: Source: Enable SMAC/SIP matching Destination: Enable DMAC/DIP matching
4.37.2
QoS Ingress Port Classification Buttons Save: Click to save all changes Reset:
Click to undo any changes made locally and revert to previously saved values
SMB - CLI UM
Rev: 1.1
Page 168 of 275
www.amphenol-socapex.com
Tel : +33(0)4.50.89.28.00
Made with FlippingBook interactive PDF creator