2.3
Configuration Commands
The CLI – Configuration section of this manual describes how to configure the RES-SCE-8MG™ Gigabit Ethernet Switch, using the RES-SCE-8MG™ Command Line interface. Many parameters may be configured from the Web User interface described later in this manual (3 Web Interface – Introduction on page 68). Input: AMP8MG# config Ouput (prompt changes): AMP8MG(config)# AAA Set the Authentication, Authorization, and Accounting parameters for the authentication login. Syntax: aaa authentication login { console | http } { { local | radius } [ { local | radius } [ { local | radius } ] ] } console: Configure Console http: Configure HTTP local: Use local database for authentication radius: Use RADIUS for authentication Access Set the Access Management configuration. access management <access_id> <access_vid> <start_addr> [ to <end_addr> ] { [ web ] [ snmp ] | all } <access_id>: ID of access management entry, values are 1-16 <access_vid>: The VLAN ID for the access management entry, values are 1-4095 <start_addr>: Start IPv4 address <end_addr>: End IPv4 address Access-List ACE Configure the ACL Ports parameters (Access Control Entry - ACE) of each switch port. These parameters will affect frames received on a port unless the frame matches a specific ACE. Syntax: access-list ace <ace_id> [update] <parameter-name>< parameter-value> <ace_id>: ID of ace entry, value can be 1-256 [update]: Update an existing ACE
2.3.1
2.3.2
2.3.3
2.3.3.1
Access-List ACE Action Configure the ACE action to be taken. Syntax:
SMB - CLI UM
Rev: 1.1
Page 17 of 275
www.amphenol-socapex.com
Tel : +33(0)4.50.89.28.00
Made with FlippingBook interactive PDF creator