Rate Set or show the rate for the policer. The default value is 500. This value is restricted to: when the “Unit” is: 100-1,000,000 “kbps” or “fps” 1-3,300 “Mbps” or “kfps”
Unit Set or show the unit of measure for the policer rate as kbps, Mbps, fps, or kfps. The default value is “kbps”. Flow Control Enable or disable the flow control.
Enabled – flow control is enabled on this switch port
Disabled – flow control is disabled on this switch port (This is the default.) If flow control is enabled and the port is in flow control mode, then pause frames are sent instead of discarding frames.
4.38.2
QoS Ingress Port Policers Buttons Save: Click to save all changes Reset:
Click to undo any changes made locally and revert to previously saved values
SMB - CLI UM
Rev: 1.1
Page 170 of 275
www.amphenol-socapex.com
Tel : +33(0)4.50.89.28.00
Made with FlippingBook interactive PDF creator