Disabled – the queue shaper is disabled for this queue on this switch port (This queue shaper is disabled by default.) Queue Shaper Rate Set or show the rate for the queue shaper. The default value is 500. This value is restricted to: when the “Unit” is: 100-1,000,000 “kbps” 1-3,300 “Mbps” Queue Shaper Unit Set or show the unit of measure for the queue shaper rate as “kbps” or “Mbps”. The default value is “kbps”. Queue Shaper Excess Set or show whether the queue is allowed to use excess bandwidth.
Enabled – the queue is allowed to use excess bandwidth
Disabled – the queue is not allowed to use excess bandwidth (The queue is not allowed to use excess bandwidth by default.) Queue Scheduler Weight Set or show the weight for this queue. The default value is “17”. This value is restricted to 1-100. This parameter is only shown if “Scheduler Mode” is set to “Weighted”. Queue Scheduler Percent Show the weight in percent for this queue. This parameter is only shown if “Scheduler Mode” is set to “Weighted”. Port Shaper Enable Set or show whether the port shaper is enabled for this switch port.
Enabled – the port shaper is enabled for this switch port
Disabled – the port shaper is disabled for this switch port (The port shaper is disabled for this switch port by default.) Port Shaper Rate Set or show the rate for the port shaper. The default value is 500. This value is restricted to: when the “Unit” is: 100-1,000,000 “kbps” 1-3,300 “Mbps” Port Shaper Unit Set or show the unit of measure for the port shaper rate as “kbps” or “Mbps”. The default value is “kbps”.
SMB - CLI UM
Rev: 1.1
Page 173 of 275
www.amphenol-socapex.com
Tel : +33(0)4.50.89.28.00
Made with FlippingBook interactive PDF creator