Access-List Shutdown Shut down incoming port. The shutdown feature only works when the packet length is less than 1518 (without VLAN tags). Syntax: access-list shutdown
Note:
To re-enable a port that was shut down, use the Access-List Port-State
command described on page 26.
2.3.16.2
(Interface – Port Type) Aggregation Create an aggregation group. Syntax: aggregation group <v_uint> Example: aggregation group 1
2.3.16.3
(Interface – Port Type) Do Use the do command to run exec commands in config mode. Syntax: do <command>
2.3.16.4
(Interface – Port Type) dot1x Dot1x is the IEEE Standard for port-based Network Access Control. This command sets dot1x per port. Dot1x Port Control Set the port security state, values are: force-authorized: port access is allowed force-unauthorized: port access is not allowed auto: port-based 802.1X authentication mac-based: switch authenticates on behalf of the client Syntax: dot1x port-control { force-authorized | force-unauthorized | auto | mac-based }
Dot1x Re-authenticate Refresh (restart) 802.1X authentication process. Syntax: dot1x re-authenticate
2.3.16.5
(Interface – Port Type) Duplex Set the interface duplexity. Values are: half: forced half duplex full: forced full duplex auto: auto negotiation of duplex mode, with an optional specification:
SMB - CLI UM
Rev: 1.1
Page 27 of 275
www.amphenol-socapex.com
Tel : +33(0)4.50.89.28.00
Made with FlippingBook interactive PDF creator