2.3.28
Privilege Set the command privilege parameters, to allow or deny access to specific parameters. Syntax: privilege { exec | configure | config-vlan | line | interface | if-vlan | ipmc-profile | snmps-host | stp-aggr | dhcp-pool | rfc2544- profile } level <privilege> <cmd> exec: exec mode configure: global configuration mode config-vlan: VLAN Configuration Mode line: line configuration mode interface: port list interface Mode if-vlan: VLAN interface Mode ipmc-profile: IPMC Profile Mode snmps-host: SNMP Server Host Mode stp-aggr: STP Aggregation Mode dhcp-pool: Dynamic Host Configuration Protocol (DHCP) Pool Configuration Mode rfc2544-profile: RFC2544 Profile Mode level: set privilege level of command <privilege>: privilege level, values are 0-15 <cmd>: initial valid words and literals of the command to modify, in 128 characters
2.3.29
QoS Quality of Service.
QosS QCE Refresh Refresh a QoS Control Entry (QCE) tables in hardware. Syntax: qos qce refresh QosS QCE Update Update an existing QCE (QoS Control Entry). Syntax: qos qce { [ update ] } <qce_id> [ { next <qce_id_next> } | last ] [ interface ( <port_type> [ <port_list> ] ) ] [ smac { <smac> | <smac_24> | any } ]
[ dmac { <dmac> | unicast | multicast | broadcast | any } ] [ tag { [ type { untagged | tagged | c-tagged | s-tagged | any } ] [ vid { <ot_vid> | any } ] [ pcp { <ot_pcp> | any } ]
SMB - CLI UM
Rev: 1.1
Page 48 of 275
www.amphenol-socapex.com
Tel : +33(0)4.50.89.28.00
Made with FlippingBook interactive PDF creator