Trap Config Name Set a user defined name for the trap configuration. The allowed string length is 0 to 255, and the allowed content is ASCII characters from 33 to 126. (Existing trap names cannot be changed. To change a trap name, delete the trap and recreate it with a new name.) Trap Mode Set the SNMP trap mode operation: Enabled: Enable SNMP trap mode operation Disabled: Disable SNMP trap mode operation (This is the default mode.)
Trap Version Show the SNMP trap supported version. Possible versions are: SNMP v1: Set SNMP trap supported version 1 SNMP v2c: Set SNMP trap supported version 2c SNMP v3: Set SNMP trap supported version 3
Trap Community Set the community access string to be used when sending SNMP trap packet. The allowed string length is 0 to 255, and the allowed content is ASCII characters from 33 to 126. Trap Destination Address Set the SNMP trap destination address. Requires a valid IP address in dotted decimal notation (‘x.y.z.w’) Trap Destination Port Set the SNMP trap destination port. The SNMP Agent will send an SNMP message via this port; the port range is 1 - 65535. Trap Inform Mode Set the SNMP trap inform mode operation: Enabled: Enable SNMP trap inform mode operation Disabled: Disable SNMP trap inform mode operation (This is the default mode.) Trap Inform Timeout (seconds) Set the SNMP trap inform timeout. The allowed range is 0 to 2147 seconds. Trap Inform Retry Times Set the SNMP trap inform retry times. The allowed range is 0 to 255. Trap Probe Security Engine ID Set the SNMP trap probe security engine ID mode of operation: Enabled: is the default mode.) Disabled: Disable SNMP trap probe security engine ID mode of operation Applicable Only to SNMP version: SNMPv3 Enable SNMP trap probe security engine ID mode of operation (This
SMB - CLI UM
Rev: 1.1
Page 94 of 275
www.amphenol-socapex.com
Tel : +33(0)4.50.89.28.00
Made with FlippingBook interactive PDF creator