RES-SCE-8MG - SMB CLI - User Manual Rev 1.01 - A TERMINER

After the Interface is enabled the user can configure each trap type separately:

None:

Disable this trap

Specific:

Enable this trap only for specific ports (a table opens, see the

table below)

All switches:

Enable this trap for all switches (This is the default mode.)

AAA Set or show the AAA group’s traps. Possible traps are:

Authentication Fail

Enable SNMP trap authentication failure trap

Disable SNMP trap authentication failure trap (This is the default.)

Switch Set or show the Switch group’s traps. Possible traps are:

STP

RMON

Enable the specified Switch group Trap

Disable the specified Switch group Trap (This is the default.)

4.14.3.3

SNMP Trap Configuration Buttons Save: Click to save all changes Reset:

Click to undo any changes made locally and revert to previously saved values

SMB - CLI UM

Rev: 1.1

Page 96 of 275

www.amphenol-socapex.com

Tel : +33(0)4.50.89.28.00