Base Cabinets
Shelf Installation and Adjustment
Side Corner Front of Cabinet Opening
Shelves are supported by adjustable shelf clips. Shelves are adjustable vertically in increments of 2”. Steps: 1. Mount clips in each of the four corners at the desired height. 2. Tilt the shelf at an angle to place it in the cabinet, being careful not to scratch the inside of the cabinet. 3. At extreme shelf locations (top or bottom), it may be desirable to mount the rear clips first, then place the shelf on them. Then install the front clips while holding up the front of the shelf. Removing and Installing Back Access Panels Base cabinets are equipped with removable back and bottom panels for access to wall receptacles and plumbing. These panels are easily removed. (Note: Units with only drawers have an open bottom without bottom panels.). Steps: 1. Empty the cabinet and remove the shelves. 2. Slide the back panel upward, then tilt the bottom of the panel forward and remove it from the cabinet.
Mount Clips for Shelves
Back Center of Cabinet
Panel Knockout Tabs
Panel slides up and down for removing and adding panels
The panels have a folded edge that will fit securely on the support tabs on the cabinet.
7
Made with FlippingBook interactive PDF creator