This is an interactive catalogue showcasing all our printing solutions offered to you. Click the links and videos within the catalogue for more information.
Email: techsupport@jgelectronics.com
Tel: 011 789 6033 Fax: 011 781 3065
Web: www.jgelectronics.com
_________________________________________________________________________________________________
50x40cm PRESS INSTRUCTIONS NB: This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
THE DIFFERENT COMPONENTS OF YOUR 50x40cm PRESS
HANDLE
DIGITAL TIMER AND TEMPERATURE CONTROL UNIT
PRESSURE ADJUSTMENT KNOB
ON/OFF SWITCH
ELEMENT
RUBBER MAT
BOTTOM METAL PLATE
2
TEMPERATURE SETTINGS:
Press OK
P – 1 will appear
Adjust the temperature to by using the up/down arrows. For appropriate temperature settings, please refer to your paper instructions and for vinyl see below
TIMER SETTINGS:
Press OK again P – 2 will appear
Adjust the time by using the up/down arrows When desired time setting is reached, press OK again For appropriate time settings, please refer to your paper instructions or for vinyl see below
3
PRESSURE ADJUSTMENT:
Adjust the pressure by turning the adjustment knob until you have achieved the desired pressure.
To adjust the pressure you simply turn the Knob, to increase the pressure you turn it clock wise (to the right)
and to decrease the pressure you turn it anti clock wise (to the left).
PRESSING HEAT TRANSFER VINYL ONTO T-SHIRTS:
1. Take the design you have cut with your vinyl cutter and take out the pieces you do not require. 2. Pre-heat heat press to 165°C and set the timer to 10 - 12 seconds. 3. Place T-shirt on top of the rubber mat and position same as required. 4. Close the press by pulling the handle down and locking it for 5 seconds to remove all the creases from the shirt. 5. The pressure should be MEDIUM for t-shirts. 6. Adjust your pressure accordingly by turning the adjustment knob 7. Place design on the T-shirt and press for the required time as indicated. 8. Open the press when the beep sounds 9. Rub with a cloth over the design before removing the plastic backing 10. Peel warm 11. Place the silicone sheet over the pressed design and repress for 2 seconds to seal the edges
Pre-heat the press to 150°c and set the timer to 7 seconds when using the following heat transfer vinyls:
Reflective,
Glow in the dark; or
Puff vinyl
4
When doing layering with more than one colour vinyl on top of the other, half the press time to 6 seconds per layer so that you do not burn the glue on the bottom layers. If this happens, your vinyl will peel off as there is nothing sticking it to the shirt.
T-SHIRT (HEAT TRANSFER) VINYL & HEAT PRESS
Page 1 Page 2 Page 3 Page 4Made with FlippingBook - professional solution for displaying marketing and sales documents online