This is an interactive catalogue showcasing all our printing solutions offered to you. Click the links and videos within the catalogue for more information.
Email: jaco@jgelectronics.com Web: www.jgelectronics.com
Tel: 011 789 6033
Fax: 011 781 3065 _________________________________________________________________________________________________ MUGGIT PEN PRESS INSTRUCTIONS NB: This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
THE DIFFERENT COMPONENTS OF YOUR PEN PRESS
HANDLE
PRESSURE ADJUSTMENT KNOB
TOP METAL PLATE WITH RUBBER PAD
INDUSTRIAL HEAT RESISTANT COATING
DIGITAL TIMER AND TEMPERATURE CONTROL UNIT
BOTTOM RUBBER WITH SLOTS
BASE OF PRESS
ON/OFF SWITCHES
START TIMER BUTTON
2
• Digital Timer and Digital Temperature Control (calibrated in Johannesburg) • Heavier than usual construction of handle (our spec) • Reinforced Pig Tail (Temperature sensor) for more reliable readings • Adjustable pressure • 12 Month manufacturer’s warranty
TEMPERATURE SETTING:
Press SET
•
SP will appear
•
• Adjust the temperature by using the up/down arrows.
TIME SETTING:
Press SET again St will appear
•
•
• Adjust the time by using the up/down arrows • When desired time setting is reached, hold SET in until both time and temperature are displayed
PRESSURE ADJUSTMENT:
3
The adjustment knob is located at the top of the top metal plate, as shown in the picture below. To adjust for MORE PRESSURE , turn the knob CLOCKWISE and for LESS PRESSURE , turn it ANTI-CLOCKWISE .
Make sure your pressure is set correctly before switching your press on.
PRESSING PENS:
1. Use PVC (hard plastic) / recycled paper pens.
2. For use with Full colour Multi-trans, pre-heat heat press to 150°C and set the timer to 20 seconds . 3. Use MEDIUM pressure (guideline only). 4. Cut out and attach the print to the pen with heat tape (the heat tape must not cover any part of the design itself). 5. Place the pens on the bottom rubber in the slots.
6. Close the press and make sure the top rubber pad lines up with your print to cover it completely when press is closed.
4
7. Press the RED BUTTON to start the timer.
8. When the timer alarm sounds, open the press and remove the pen. 9. Rub hard over the print with a cloth. 10. Let the pen cool down completely. 11. Remove the heat tape and the Multi-trans paper. 12. To make the print scratch resistant , we recommend the use of our Muggit Varnish spray to cure the print. 13. Please follow the application instructions on the can .
Page 1 Page 2 Page 3 Page 4Made with FlippingBook - professional solution for displaying marketing and sales documents online