GWO BST V14.0

GWO Basic Safety Training V14.0

2021-04-01_TS_BST_V14

Demonstrate how to perform pre-use inspection of the rescue device products required/chosen to instruct this Module, by the following principles and covering:

a. Markings and labels

b. Equipment is within period of formal inspections

c. The rope has no damage and the end terminations are in good condition

d. The rope runs freely through the device in both directions

e. Checking for integrity and the absence of damage, corrosion, saltwater/chemical/lubricant/dirt exposure or contamination

f. Checking for the absence of significant wear of the device

g. Carabiners/connectors operate and lock as intended and cannot disconnect completely

h. Rope securing mechanism works properly

i. Observe product operating temperature range

Demonstrate how to rig the device onto a ladder stile and reinforced rung utilising slings, on one side and in a centre position of the ladder system – aiming to enable moving parts of the device to run freely

Explain and demonstrate the principles of lifting angle, angle factor and edge protection

Demonstrate how to rig the device in passive mode setup, and active (inverted) mode setup with deflection/deviation applying a friction carabiner Stress the generic approach in pre-use inspecting and using a rescue device focusing on similarities and differences in design, functionality and operation between different products Explain the potential task placed upon the participant in their own organisation on course completion, requiring them to familiarise themselves with other safety equipment products

MEASURES TO PREVENT INJURY DURING TRAINING

20 min.

The aim of this lesson is to reduce the risk of injury during training by ensuring that the participants are briefed in the control measures employed in the practical training area and to warm up prior to performing rescue exercises.

Note:

This lesson is repeated from lesson 9 with the intention of teaching the participants good habits of warming up prior to working.

ELEMENT 15.1 - CONTROL MEASURES AND WARM-UP

The instructor shall:

Global Wind Organisation www.globalwindsafety.org

99 / 206

Made with FlippingBook - Online magazine maker