Pew Ends
Pews Bodies
22.5”
Pew ends are solid red oak, 2” thickness with butcher block or two-ply construction. Full pew ends have a separate 3” high foot glued, doweled and screwed to the pew end. This provides the support for anchoring to the floor. Pew ends are anchored to the floor with concealed fasteners, one per end. Two anchors are also available upon request. Pew supports are solid red oak, two-ply 1.5” thickness. Each panel is .75” thickness. Following are standard Woerner pew ends. Custom designs are available upon request.
15.5”
4.875”
Pew seats, backs and ends can be manufactured in various combinations to meet your specific requirements. We offer three basic pew body designs which follow:
101 Solid wood seat and back Seats are machined from 6/4 lumber (1.50” raw lumber thickness). Final thickness will be approximately 1-3/16”. Seats have a scooped out contoured area for comfort. Boards are glued up with tongue and groove construction. Seats are reinforced under- neath with a 1.5” thickness x 2.5” height lateral brace. Backs are machined from 4/4 lumber (1” raw lumber thickness). Final thickness will be approzimately .75”. Boards are glued up with tongue and groove construction. The cap rail is fastened to the pew back with tongue and groove construction.
33.0”
1.125”
31.125”
17.0”
14.375”
526 Pew End
530 Pew End
576 Pew End
584 Pew End
546 Pew End
563 Pew End
16.625”
21.875”
16.875”
4.875”
102 Padded seat and wood back Seats are manufactured with a .75” veneer core plywood base with solid poplar rails across the front and back for support and anchoring. Foam is 4” thickness with 2.6# density and 45 – 48# compression ratio. Many fabrics are available for a covering. Backs are machined from 4/4 lumber (1” raw lumber thickness). Final thickness will be approzimately .75”. Boards are glued up with tongue and groove construction. The cap rail is fastened to the pew back with tongue and groove construction.
33.0”
0.75”
31.25”
549 Pew End
542 Pew End
551 Pew End
541 Pew End
578 Pew End
564 Pew End
585 Pew End
18.5”
12.5”
16.625”
22.875”
16.875”
4.875”
103 Padded seat and back Seats are manufactured with a .75” veneer core plywood base with solid poplar rails across the front and back for support and anchoring. Foam is 4” thickness with 2.6# density and 45 – 48# compression ratio. Many fabrics are available for a covering. Backs are machined from 4/4 lumber (1” raw lumber thickness). Final thickness will be approzimately .75”. Boards are glued up with tongue and groove construction. The cap rail is fastened to the pew back with tongue and groove construction. The front of the pew back is covered with 1” foam and fabric which are removable for recovering at a future date.
532 Pew End
555 Pew End
571 Pew End
580 Pew End
539 Pew End
556 Pew End
33.0”
0.75”
31.25”
18.5”
12.5”
16.625”
573 Pew End 527 Pew End (Note: 585, 564, and 563 are also available without white finish)
533 Pew End
577 Pew End
587 Pew End
23
24
153
800.289.7668, option 6
RootCandlesChurch.com
152
Made with FlippingBook - Share PDF online