USING BABY TYLER
Setup Make sure your manikin and monitor both have batteries installed before continuing with these steps.
Understanding Feedback Here’s a quick guide to monitor feedback.
IMPORTANT NOTE! If you have a brand new manikin, the serial number on the back of the manikin must match the one on the back of the monitor! If you are connecting a replacement monitor, follow the reset instructions on page 45.
1. Make sure your manikin and monitor both have batteries installed. 2. Turn on the monitor with the power button and turn on Baby Tyler by compressing the chest until you hear a beep. 3. Choose the mode in which you will be training. • By default, the monitor starts in standard mode. • To switch to bind mode, tap the mode button. If you want to switch back, just press it again! 4. Start your CPR training!
QUALITY CPR Green in the center ovals means you’re hitting the right rate, depth & recoil!
NEEDS WORK Red in the upper or lower lights means a few different things. See below!
TOO SHALLOW
IDEAL RATE
IDEAL DEPTH & RECOIL
TOO FAST
TOO DEEP
TOO SLOW
NEEDS MORE RECOIL
TEST REPORT Appears 10 seconds after session ends.
42
43
BABY TYLER
Made with FlippingBook Digital Proposal Creator