• Step 2: Instructions will be displayed on screen to guide you through the edge teach procedure. Follow the on- screen instructions for positioning your optical probe and performing the calibration. • Step 3: At the completion of the teach calibration a message will be displayed indicating success or failure. In the event of teach failure please refer to the section of the Mx200 setup guide on Optical Edge setup. After a successful teach calibration, the optical edge probes can be used to perform feature measurements. Edge Logic Edge Logic is an optical edge measurement function that reduces measurement time by enabling the gesture-driven control of start and stop measure commands and by automatically determining and entering the feature type for line and circle features. 8.11
Note : It may be necessary to enable the Edge Logic function in the Mx200 setup menus. To enable EdgeLogic navigate to the Mx200 Settings, then access the setup screen called “Optical Edge” and set the enable flag for EdgeLogic to “Yes”.
To use the Edge Logic function: • Step 1: Select the Auto Edge probe from the Probe menu. • Step 2: Cross the same feature edge twice, once in each direction to start the measurement. The feature measurement will be initiated.
• Step 3: Probe the desired sequence of points to define the feature. • Step 4: After probing the desired points for the feature, cross the same point twice in each direction to finish the measurement. The feature will be added to the feature list.
28
Made with FlippingBook - professional solution for displaying marketing and sales documents online