4.0
Exporting values via RS232
The Mx100 can send either the current stage position(XYZQ) out of the RS232 port. The port needs to be properly configured, and the correct cable needs to be used in order to successfully send the data. The “RS232” settings screen contains setup parameters for configuring the general-purpose IO port for on the Mx100 readout for serial data output. The port parameters configured on the Mx100 should match that of the connected device (PC). Note : The general purpose IO port on the Mx100 is used for both serial data transfer and button input. As such the wiring for the connection cable must be specific to the connection modes being used. Please see the signal assignment diagram at the end of this section for reference.
RS232 Function
Description
Configure Baud rate for connection. 110 through 115,200 can be chosen using the appropriate softkey. Configure the correct parity mode for the connection. Even/Odd/No can be selected using the appropriate softkey. Configure the correct number of Stop Bits for the connection. 1 or 2 can be chosen using the appropriate softkey. Specifies whether or not the coefficient label will be sent along with the value. Set to Yes or No using the appropriate softkey. Specifies whether or not the unit type for a given value is sent along with the value. Set to Yes or No using the appropriate softkey. Configures the desired character to be sent at the end of an output line. CR(Carriage Return), Line Feed(LF) or CR &LF can be selected using the appropriate softkey. EOL can also be set to None. Configures the desired field delimiter(separator) to Comma or Tab. Set to desired delimiter using the appropriate softkey.
Baud Rate
Parity
Stop Bits
Send Labels
Send Units
Send Eol(End of Line)
Field Delimiter
10
Made with FlippingBook - professional solution for displaying marketing and sales documents online