Ball and Young Underlay - IMO Certificate MED B

Page 1 / 3

Certificate number: 44623/A1 MED File number: ACI1310/108/001 Item number: MED/3.18c

USCG Module B number: 164.117 / EC2690 This certificate is not valid when presented without the full attached schedule composed of 7 sections www.veristar.com

Notified Body 2690 - MARINE EQUIPMENT DIRECTIVE 2014/90/EU

EC TYPE EXAMINATION CERTIFICATE as per Module B of Directive 2014/90/EU of the European Parliament and of the Council of 23 July 2014 as transposed in the French Regulations and Commission Implementing Regulation (EU) 2017/306 of 06 Feb. 2017

This certificate is issued to: BALL & YOUNG LTD. CORBY - UNITED KINGDOM

for the type of product SURFACE MATERIALS AND FLOOR COVERINGS WITH LOW FLAME-SPREAD CHARACTERISTICS: FLOOR COVERINGS Floor Coverings / Carpet underlays - Type "CAST IRON FR / CONTRACT 6 mm FR / CRUISE LINER FR" and type "Cloud 9 Flame Retardant 6 / Cloud 9 Flame Retardant 8"

Requirements: SOLAS 74 convention as amended, Regulations II-2/3, II-2/5, II-2/6, II-2/9, X/3

IMO Res. MSC.36(63) -(1994 HSC Code)- as amended, 7 IMO Res. MSC.97(73) -(2000 HSC Code)- as amended, 7 IMO Res MSC.307(88) -(2010 FTP Code)- IMO MSC/Circ.1120

This certificate is issued on behalf of the French Maritime Authorities to attest that Bureau Veritas Marine & Offshore did undertake the relevant type-examination procedures for the product identified above which was found to comply with the relevant requirements of the Directive 2014/90/EU of the European Parliament and of the Council of 23 July 2014 as transposed in the French Regulations.

This certificate will expire on: 11 Apr 2021

For Bureau Veritas Marine & Offshore Notified Body 2690, At BV LONDON, on 10 Nov 2017, Spencer Yule

This certificate does not allow to issue the Declaration of Conformity and to affix the mark of conformity (wheelmark ) to the products corresponding to this type. To this end, the production-control phase module (D, E or F) of Annex II of the Directive is to be complied with and controlled by a written inspection agreement with a notified body. This certificate remains valid until the date stated above, unless cancelled or revoked, provided the conditions indicated in the subsequent page(s) are complied with and the product remains satisfactory in service. This certificate will not be valid if the applicant makes any changes or modifications to the approved product, which have not been notified to, and agreed in writing with Bureau Veritas Marine & Offshore. Should the specified regulations or standards be amended during the validity of this certificate, the product(s) is/are to be re-approved prior to it/they being placed on board vessels to which the amended regulations or standards apply. Bureau Veritas Marine & Offshore is designated by the French Maritime Authority as a "notified body" under the terms of the French Regulations Division 140 Chapter 140-2. This certificate is issued within the scope of the General Conditions of Bureau Veritas Marine & Offshore available on the internet site www.veristar.com. Any Person not a party to the contract pursuant to which this document is delivered may not assert a claim against Bureau Veritas Marine & Offshore for any liability arising out of errors or omissions which may be contained in said document, or for errors of judgement, fault or negligence committed by personnel of the Society or of its Agents in establishment or issuance of this document, and in connection with any activities for which it may provide.

The electronic version is available at: http://www.veristarpm.com/veristarnb/jsp/viewPublicPdfTypec.jsp?id=wadjb5upqg BV Mod. Ad.E 536 June 2017

This certificate consists of 3 page(s)

Page 2 / 3 Certificate number: 44623/A1 MED

THE SCHEDULE OF APPROVAL

1. PRODUCT DESCRIPTION:

CAST IRON FR/ CONTRACT 6 mm FR / CRUISE LINER FR Floor covering/carpet underlay made of polyurethane re-bonded chip foam core (6 mm - 140 kg/m³) with grey polyethylene film (20-30 µm - 15-25 g/m²) laminated to bottom surface and white polypropylene non-woven (40 µm - 40 g/m²) laminated to the top surface. Thickness : about 8 mm Mass per unit area : 909 g/m² For the test, the product was glued on a 3 mm steel plate by means of adhesive Styccobond F40 (application rate 120 g/m², manufactured by F Ball & Co. Ltd). CLOUD 9 FLAME RETARDANT 6 & 8 Floor covering/carpet underlay made of a reconstituted polyurethane chip foam type "160 CMP BY" (density 160 kg/m³) with a printed polyethylene film type "MC00007" (25-30 µm - 30 g/m²) laminated to the top surface and with a grey polyethylene film "type MC00006" (25-30 µm - 25 g/m²) laminated to the bottom surface. Thickness : about 6 mm (Cloud 9 Flame Retardant 6) / 8 mm (Cloud 9 Flame Retardant 8) Mass per unit area : 1015 g/m² (Cloud 9 Flame retardant 6) / 1334 g/m² (Cloud 9 Flame retardant 8) For the tests, the products were glued on a 3 mm steel plate by means of adhesive Styccobond F40 (application rate max 250 g/m², thickness 0.1 mm, manufactured by F Ball & Co. Ltd, UK).

2. DOCUMENTS AND DRAWINGS: 2.1 - CAST IRON FR/ CONTRACT 6 mm FR / CRUISE LINER FR : Technical data sheet, issue 1 dated 06/01/16

2.2 - CLOUD 9 FLAME RETARDANT 6 : Technical data sheet, issue 6 dated 04/09/17

2.3 - CLOUD 9 FLAME RETARDANT 8 : Technical data sheet, issue 4 dated 04/09/17

3. TEST REPORTS : 3.1 - CONTRACT 6 mm FR :

Test report N°358192 Issue 1, dated 17/11/2015, as per IMO 2010 FTP Code , Annex 1, Part 5, from Exova Warringtonfire, UK Test report N°359895 Issue 1, dated 20/01/2016, as per IMO 2010 FTP Code , Annex 1, Part 2, from Exova Warringtonfire, UK 3.2 - CRUISE LINER FR : Test report N°358903 Issue 1, dated 17/11/2015, as per IMO 2010 FTP Code , Annex 1, Part 5, from Exova Warringtonfire, UK Test report N°359896 Issue 1, dated 20/01/2016, as per IMO 2010 FTP Code , Annex 1, Part 2, from Exova Warringtonfire, UK 3.3 - CAST IRON FR : Test report N°358904 Issue 1, dated 17/11/2015, as per IMO 2010 FTP Code , Annex 1, Part 5, from Exova Warringtonfire, UK Test report N°359897 Issue 1, dated 20/01/2016, as per IMO 2010 FTP Code , Annex 1, Part 2, from Exova Warringtonfire, UK 3.4 - CLOUD 9 FLAME RETARDANT 6 : Test report n° 386341 dated 01/09/2017 as per as per IMO 2010 FTP Code, Annex 1, Part 5 issued by Exova Warringtonfire, UK. Test report n° 385143 dated 03/08/2017 as per as per IMO 2010 FTP Code, Annex 1, Part 2 issued by Exova Warringtonfire, UK. 3.5 - CLOUD 9 FLAME RETARDANT 8 : Test report n° 386343 dated 01/09/2017 as per as per IMO 2010 FTP Code, Annex 1, Part 5 issued by Exova Warringtonfire, UK. Test report n° 385144 dated 03/08/2017 as per as per IMO 2010 FTP Code, Annex 1, Part 2 issued by Exova Warringtonfire, UK. 4. APPLICATION / LIMITATION: 4.1 - CAST IRON FR/ CONTRACT 6 mm FR / CRUISE LINER FR : t his product is to be used as floor covering or primary deck covering only. 4.2 - CLOUD 9 FLAME RETARDANT 6 & 8 : t his product is to be used as floor covering only (not suitable as primary deck covering).

4.3 - The fitting aboard to be the same as used for the test.

The electronic version is available at: http://www.veristarpm.com/veristarnb/jsp/viewPublicPdfTypec.jsp?id=wadjb5upqg BV Mod. Ad.E 536 June 2017

This certificate consists of 3 page(s)

Page 3 / 3 Certificate number: 44623/A1 MED

4.4 - The products may be applied over any low flame-spread floor covering, steel or non-combustible material.

5. PRODUCTION SURVEY REQUIREMENTS: This certificate alone does not allow the applicant to issue the Declaration of Conformity and to affix the mark of conformity (wheelmark) to the products corresponding to this type. To this end, the production-control phase module D "Production Quality Assurance" or E "Product Quality Assurance" or F "Product Verification" of Annex II of the Directive is to be complied with and controlled by a written inspection agreement with a Notified Body.

6. MARKING OF PRODUCT: 6.1 - Reference is made to MED 2014/90/EU chapter 2.

In particular Article 10.3 specifies that the wheelmark shall be followed by the identification number of the Notified Body involved in the production control phase (module D, E or F) and by the year in which the mark is affixed (4 digits or last 2 digits). 6.2 - In pursuance of the EU/US MRA+, and in accordance with the Council Decision 2004/425/EC of 21 April 2004, the product(s) marked as per MED 2014/90/EU may be marked with the USCG conformity marking as authorized by the Notified Body undertaking surveillance module. 7. OTHERS: 7.1 - It is BALL & YOUNG (VITAFOAM) Ltd 's responsibility to inform shipbuilders or their sub-contractors of the proper methods of fitting, use and general maintenance of the approved equipment and the conditions of this approval.

7.2 - This Certificate supersedes EC Type Examination Certificate n°44623/A0 EC issued on 11/04/2016 by the Society.

*** END OF CERTIFICATE ***

The electronic version is available at: http://www.veristarpm.com/veristarnb/jsp/viewPublicPdfTypec.jsp?id=wadjb5upqg BV Mod. Ad.E 536 June 2017

This certificate consists of 3 page(s)

Page 1 Page 2 Page 3

Made with FlippingBook - Online catalogs