Operations training
Crane and Hoist / V1 2023-07-03
8. MODULE 2- CRANE AND HOIST INSPECTION AND MAINTENANCE 8.1 Aims and Objectives for the Crane & Hoist Inspection and Maintenance Module The aim of the training is to enable the technician to inspect, maintain, and test fixed small cranes and fixed hoists complying with relevant legislation and according to relevant manufacturer’s inspection and maintenance manuals and documents.
Further lifting equipment-specific training must be expected in order to perform inspection and maintenance of lifting equipment on site: depending on the duty holder’s requirements.
Note
Learning objectives:
1) The participants can recognise the importance of inspecting and maintaining cranes and hoists in accordance with manufacturers’ manuals and legislation (Knowledge, basic level) 2) The participants can take responsibility to perform inspection and maintenance on multiple crane and hoist types, following relevant manuals and documents (Ability, intermediate level)
The participant will furthermore be able to perform statutory inspections on cranes and hoists if local legislation, manufacturer’s manuals & guidance, and company requirements permit.
Note
8.2 Target Group Personnel, who inspect and maintain lifting equipment within the wind industry. 8.3 Duration of the Crane and Hoist Inspection and Maintenance training The total contact time for completing the Crane and Hoist Inspection and Maintenance Module is 12 hours and 30 min.
The training provider must not exceed the time per day given in the table 8.3.1 below.
Maximum Duration Per Day
Contact time
8 hours
Total training day
10 hours
Table 8.3.1 - Maximum durations for training day
Note
Contact time includes delivery of course lesson content, practical exercises and activities directly related to these.
Global Wind Organisation ©2023 / www.globalwindsafety.org
42 / 107
Made with FlippingBook interactive PDF creator