Operations training
Crane and Hoist / V2 02052025
Use the manufacturer’s manual for the correct inspection and maintenance of the hoist Use the manufacturer’s manual for the correct inspection and maintenance of the hoist
Carry out extended inspection and maintenance of hoist, for example 5 years inspection
Shackles, torque wrench, chain hoist, load cell, slings. All lifting equipment must be within certification date (correct colour code) A multi choice assignment, where some questions may have more than one possible correct answers
Carry out all the necessary load tests
The test is planned to be an individual test
Theory test on topics from the module (primarily learning objectives aiming at knowledge) that are not covered in the practical assignments in lesson 9
The participants must be informed if this is a formative or a summative test
The above shown exercises are examples of content for exercises for maintaining cranes and hoists. Training scenario 2 and 3 may be bundled if the example crane has a hoist mounted on it
Note
TROUBLESHOOTING AND FAULT FINDING ACCORDING TO
MANUFACTURERS’ MANUALS
90 min.
The aim of this lesson is to prepare the participants to perform fault finding on lifting equipment by practising how to recognise faults, and to identify solutions, use the relevant manufacturers’ manuals.
Learning objective:
40) The participants can take responsibility for identifying and rectifying faults on fixed small cranes and hoists according to the manufacturers’ manuals (Ability, intermediate level)
The instructor shall:
Prepare or simulate a number of commonly experienced faults on the lifting equipment or on individual components
Demonstrate how to perform troubleshooting using the error codes from the relevant maintenance manual
Global Wind Organisation ©2025 / www.globalwindsafety.org
69 / 111
Made with FlippingBook interactive PDF creator