CCHD Garage CCHD Garage is assembled and installed differently than our other products. It has no rafix cams and instead, is assembled as a box cabinet with a full 3/4" back and then screwed to the wall. It uses 2” confirmat screws to assemble and then normal wood screws with finish washers to attach to the wall. The top & bottom fixed shelves and adjustable shelves are made from 1” White laminate instead of 3/4". The fixed shelves are 3/4" deeper than the adjustable shelves and can also be identified by looking for the predrilled holes around the edges, which are used to assemble the cabinets. The backs are 3/4" laminate and can also be identified by the predrilled holes around the edges. The doors & drawer fronts are full overlay instead of half. This utilizes a different hinge, as well, which can be identified by its straight-arm design instead of the hump that half overlay hinges have. Assembling the cabinets Spread blankets out on the floor to create a space large enough to assemble the cabinet. Start by standing a vertical up on its long end (where the cabinet would be laying down on the floor - the edgebanding should be up) and lining up one of the top shelves to the predrilled holes. Using 2” confirmat screws (pictured below), attach the shelf to the vertical using all available predrilled holes.
Next, lay the vertical panel down flat against the floor with the shelf you just attached sticking up in the air. Find the back and place it where it goes. Screw it into the shelf.
Add your other fixed shelf (top/bottom) and attach it to the back.
68
Made with FlippingBook. PDF to flipbook with ease