Safety training
GWO Basic Safety Training / V19 02052025
5.2.2, 5.2.4, 5.2.6 and 5.2.7 updated
•
Element 5.3 – Correct attachment and Detachment
Text updated
•
Element 5.4 – Correct use
Text updated
•
Lesson 8 – Self Retracting Lifelines
• Entire lesson has been updated. Backup lines has completely been removed and focus has been placed on the use of SLRs in actual work in wind turbines.
Element 9.1 – Measures to prevent injury during training
• 9.1.5 Instructions about additional fall protect are updated
Section 10.7
Assessment instructions made clearer to read
•
BST Working at Heights & Manual Handling Module
Section 11.2. Duration of the BST Working at Heights & Manual Handling Module
:
Text updated
•
Section 11.4. Equipment BST Working at Heights Module & Manual Handling Module
Text revised and updated, including:
•
- Explanation of generic training “ This enables the participants to conduct pre -use inspection and to use other safety equipment products compared to those taught during this module (based on the manufacturer’s user manual). However, a location specific risk assessment might identify the need for additional instructions. - The introduction of safety instruction “ Additional fall protection must always be used during training activities at height. The training provider shall introduce control measures that lower the risks and hazards associated with a fall from height to an acceptable level, following the Hierarchy of Controls in their risk assessment. ”
Section 11.5. BST Working at Heights & Manual Handling Module Timetable
:
• The table is updated according to changes in the lesson 8 and the accompanying text has been updated.
Element 5.2 – Pre-use inspection
Learning objective 30 updated
•
5.2.2, 5.2.4, 5.2.6 and 5.2.7 updated
•
Global Wind Organisation
©2025/ www.globalwindsafety.org
292 / 318
Made with FlippingBook - PDF hosting