Tool Clamp Orientation Change
The clamp position can be changed. Remove and insert the screw and adjust the orientation and re screws. The clamp position can be changed. Remove and insert the screw and adjust the orientation and re-insert the
Arm Support Arm Support Slider
Arm Length Adjustment
The travel distance of the linear arm can be increased or shortened. Remove the four screws that attach the linear arm from the arm support slider. Align the linear arm's four holes at the desired location and then insert the four and tighten. Align the linear arm's four holes at the desired location and then insert the four screws
Travel distance
Linear Arm and the four holes
Tool Balancer Adjustment
B
For LTS-15 (balancer 9312MZ) & LTS-
-25 (balancer 9313MZ) models
A
To allow the tool balancer to operate heavier loads within the load capacity accepted, turn knob (A) anticlockwise, indicated by the “+” symbol. The continuous but in steps. After each step, the knob plate (B). Proceed step by step until the desired load position is reached. For lighter loads, extract the knob (4mm indicated by the “-” symbol. After each step, the knob plate (B). Proceed step by step until the desired load position is reached. After adjusting the load, check that the balancer cord can length: the movement must not be limited by the complete winding of the spring. Check the stroke more than once and according to different speeds. After adjusting the load, check that the balancer cord can move freely along its heavier loads within the load capacity accepted, indicated by the “+” symbol. The adjustment is not fter each step, the knob must go back into contact with roceed step by step until the desired load position is reached. mm) and grip it tightly. Turn it clockwise, . After each step, the knob must go back into contact with roceed step by step until the desired load position is reached.
4mm
Note: a reduction in the ability of the balancer to hold the hanging load might mean to break. Do not operate the arm with the balancer, and contact Mountz for tool maintenance or replacement options. a reduction in the ability of the balancer to hold the hanging load might mean that the drum spring is about that the drum spring is about
SILICON VALLEY HEADQUARTERS 1080 North 11th Street, San Jose, CA 95112 | Phone: (408) 292 1080 North 11th Street, San Jose, CA 95112 | Phone: (408) 292-2214 | Fax: (408) 292-2733 | mountztorque.com
6
Made with FlippingBook Ebook Creator