Insert Power Tool in Tool Clamp 1. Loosen the two screws on the tool clamp two screws on the tool clamp.
2. Position the electric or air screwdriver vertically in the tool clamped securely. 2. Position the electric or air screwdriver vertically in the tool clamp. Tighten the two screws until the power tool is clamp. Tighten the two screws until the power tool is
Torque Arm Set-Up 1. Install the mounting adapter on a standard rail, wall, work bench. 2. Place tool balancer above work station and attach it to the power tool. Note: Arm placement should not have a greater than 45 1. Install the mounting adapter on a standard rail, wall, work bench. Rail carriage and adapte work station and attach it to the power tool. Arm placement should not have a greater than 45-degree angle.
Rail carriage and adapter sold separately
Note: It is recommended to use a tool balancer with a telescoping torque arm.
SILICON VALLEY HEADQUARTERS 1080 North 11th Street, San Jose, CA 95112 | Phone: (408) 292 1080 North 11th Street, San Jose, CA 95112 | Phone: (408) 292-2214 | Fax: (408) 292-2733 | mountztorque.com
3
Made with FlippingBook Annual report maker