COMMERCIAL LAUNDRY CapDI © for Tunable desalination and water reuse at high laundering temperatures
Proudly Represented By:
Why use CapDI for your commercial laundry facility? In commercial laundry, TDS levels above 750 ppm cause dull, gray linens. Unfortunately, the ability to affordably and reliably remove TDS at high temperatures with effective use of recycled laundry water has proven to be limited. Traditional technologies require water to be cooled before TDS removal, which means it must then be reheated for laundering. This expensive, time-consuming process is no longer necessary with the addition of CapDI. The removal of TDS at laundering temperatures allows Voltea customers to realize exceptional operational, chemical, and energy costs savings. Commercial laundries across the globe have reduced their total water consumption significantly by implementing CapDI. This technology recovers up to 95% of the water it treats, delivering whiter, brighter linens at the high temperatures laundry facilities operate (140°F/60°C). Voltea reuse solutions work across all laundry intakes; healthcare, hospitality, uniforms/industrial, and food & beverage. Voltea’s CapDI experts have developed technology and performance metrics so methodically that our predicted performance data graphics are near perfectly in-line with actual results of each system we install. This allows launderer’s to make accurate estimates of laundering times, water usage, and TDS removal while running the CapDI system. Similar data graphics are also made to represent each launderer’s current treatment system without CapDI, allowing detailed business case analysis to show just how effectively our technology can help the facility. How does it work? Water flows between electrodes in a 2-step process. Electrode surfaces are separated from the water by membranes that selectively allow positive or negative ions to pass.
Purification: Saline water passes between oppositely charged electrodes, which electrostatically remove dissolved ions, leaving pure water flowing out of the cell.
Regeneration: Feed water flushes through the cell at a lower flow rate, while electrode polarity is reversed. Ions are rejected from the electrode surface, concentrated in the flow channel, and flushed from the cell.
Voltea’s Industrial Series System 12 (IS12)
What are the benefits?
• Up to 90% TDS removal • Allows whiter, brighter linens CapDI is Tunable!
CapDI is all about results! Voltea installed an IS4 CapDI system at a commercial laundry facility in the state of Georgia where we were able to gather a series of data for the analysis of comparing the TDS removal at the site before and after CapDI was installed. The below graph shows the actual data of the TDS removal with no CapDI present; the predicted TDS As shown below, before the CapDI system was installed the facility had met their 1,000 ppm TDS limit after 8 hours of run time and had to discharge. With CapDI, however, even after 12 hours the facility had not yet met their 1,000 ppm TDS limit, therefore had no need to discharge. Using CapDI for the commercial laundry application not only saves on OpEx, but also allows longer run times, thus improving profitability. • Dynamic control subscription allows continuous monitoring of water quality by our field experts • Fully automated operation; low maintenance allows launderers to focus on their daily operations Fully Automated • Up to 95% water recovery; reduces impact to municipal water sources and aquifers • CapDI is more efficient and environmentally friendly than any other traditional technology • No chemicals required; avoids polluting aquifers and permitting requirements for discharge We Take Care of the Environment • Low energy consumption; dramatic savings • High water recovery; reduces municipal water demand • Longer run times due to TDS not reaching the 1,000 ppm discharge limit, thus maximizing profit Lowest OpEx!
Cost Savings with CapDI
TDS vs. Laundering Time
1,000 ppm limit
No CapDI Predicted
Actual Run 1 Actual Run 2 Actual Run 3 Actual Run 4
Feed/Waste Water & OPEX
Proudly Represented By:
HOMES Water +1.289.885.6H O (6446) email@example.com www.homes-water.com 2
U.S. OFFICE 1920 Hutton Court #200 Farmers Branch, TX 75234
EUROPEAN OFFICE Wasbeekerlaan 24 Sassenheim 2171 AE The Netherlands +31(0)252.200100 firstname.lastname@example.org
All Voltea trademarks and logos are owned by Voltea B.V. All other brand or product names are trademarks or registered marks of their respective owners. Because we are continuously improving our products and services, Voltea reserves the right to change specifications without prior notice. Voltea is an equal opportunity employer. CapDI for Commercial Laundry © 2016. All rights reserved.
+1.469.620.0133 www.voltea.comPage 1 Page 2 Page 3 Page 4
Made with FlippingBook - Online Brochure Maker