S ETTING THE B RAHM ™ C OLLECTOR ON THE S TAND
NOTE: Ple ase see the "Moving the Brahm™ Collector" section prior to setting the unit
on the stand.
NOTE: The dust trays and hoppers may be attached to the unit before the unit has been
placed on the stand.
The Brahm™ Collector can easily be moved by
using a fork lift truck. Place the forks under the
unit. Be mindful not to damage the dust tray or
hopper mounting angles on the bottom of the unit.
Attach the lifting chains or cables to the forklift
“headache” bar. Attach the other end of the lifting
chains or cables to the lifting lugs. Keep in mind,
the motor side of the unit is heavier and forks may
need to be shifted toward this side.
Make sure not to scratch or damage the unit.
Place cardboard between the unit and the fork lift truck to prevent damage
When possible, lift and set the unit from the back side to reduce risk of damage to the filter and dual
compartment doors.
When setting the unit, be mindful of the bottom of the unit. Make sure the unit feet are placed inside
the stand corners to prevent damage to the stand. The feet of the unit should line up with the flanges
on the corners.
Lift both halves onto the stand. Once both halves are on the stand, they can be bolted together. Make
sure to bolt the halves together before bolting the unit to the stand. If bolted to the stand first, the unit
may leak where the two halves are joined together.
Once the unit is on the stand (and halves are bolted together where applicable), the unit can be
bolted to the stand. Attach the unit to the stand using 3/8"-16 x 1" bolts. These bolts should be placed
through the flanges on the top of the stand and into the weld nuts on unit's feet. Make sure the bolts
are secured with washers and lock washers to prevent loosening over time.
Page 20
sales@clean-air.com
clean-air.com
1-866-665-1829
Made with FlippingBook Annual report maker