G ETTING S TARTED
After the unit has been installed at its final place and the electrical and compressed air line has been
connected, the unit needs to be tested to make sure that all the features run as intended. This step is usually done by Clean Air Industries installation team. Here is a quick guide to test the system and get familiar with the unit
• The first thing to do is to rotate the Power Disconnect to ON position to turn on the unit. Then,
press the green button to start the blower and red button to stop the blower. Refer to page 61
for more details.
• All Brahm Collectors are equipped with Smart Pulsing System. On auto mode, the unit will
automatically pulse to self-clean the filter. Refer to the Pulse Settings Section for more
details..
• All BC Plug and Play Units are equipped with Variable Frequency Drive. The unit will adjust
its motor speed automatically based on the condition of the filter. The speed can also be
adjusted manually from the VFD.
• (Optional) When Fire Suppression System is equipped, the unit will have louvers on the inlet
and exhaust side. During fire, the motors will stop and the louvers will automatically close to
contain and suppress the fire in the unit. There is a 20 s delay for the fire canisters between
each module to allow the louver to close and prevent voltage spike to trip the circuit breaker.
Remember, DO NOT rotate the Power Disconnect into OFF position as this will cut power off
and thus deactivate the Fire Suppression System. The BC Plug and Play is also equipped
with a backup fire tube detection system in case of loss of power, allowing the canister to still
actuate.
Important!!! On units with Fire Suppression System, the fire solenoid is in disconnected position when the unit leaves Clean Air Industries facility . This allows for the FSS to be tested onsite without actually actuating the fire canister. Check in the junction box to make sure that it is connected when the unit is
ready!
Page 22
sales@clean-air.com
clean-air.com
1-866-665-1829
Made with FlippingBook Annual report maker