Valves Valve, 3 Position, 5 Port
These valves are designed to control double acting pneumatic clamping systems. Valves can run on lubricated or unlubricated air. Cylinder exhaust is controlled by internal flow controls, allowing individual exhausts to be controlled with only one common exhaust in the end plate. If electrical power is lost, manual overrides allow the valves to be shifted. Overrides can also be used to help in system troubleshooting. Rapid return is achieved when the valve is deactuated, since the exhaust orifice is oversized. Installing the valves is aided by captive mounting parts, eliminating lost screws and seals during assembly/disassembly. Installation is made easier since the coil can be rotated in 90° increments and the grip connector moves 180°. Connections are made easily with our push-to-connect tubing. It functions with Nylon 11 tubing for inch sizes and Nylon 12 tubing for metric sizes. Standard NPT ports are used in the manifolds. Valve bodies are made of die-cast aluminum. Control valves: 5 port, 3 position ISO 1
Control Valve Model Number and Specifications P7-1021-00 ISO 1 - 5/3 CENTER BLOCKED 115V AC • 250 PSIG Must use external pilot pressure - not to exceed 150 PSIG P7-1021-01 ISO 1 - 5/3 CENTER BLOCKED 115V AC • 150 PSIG External pilot NOT required
F-6
ILSP71001 REV C
Specification
Standard Power Requirements
Seals
Ambient Temperature Range
Inlet Temperature 23˚ to 175˚F
Response Time On/Off 20/34 msec ± 20%
Duty Rating
Override
Electrical Interface
Nitrile Viton ®
5˚ to 120˚ F
Continuous at 90% to 105% of rated voltage
Manual, Locking/Non-locking
3 pin Plug In Din Connect
120V/60Hz
800-992-0236 © Vektek January 2022
Made with FlippingBook - Online Brochure Maker