Special Use Clamps
Edge Clamp Specifications
Single Acting Standard Ported and Manifold Mount
Low profile allows you to slab mill over the clamp on most parts. Downward clamping angle of the blade yields both horizontal and vertical force pushing your part firmly against locators and the work surface. Three-way porting makes plumbing multiple clamps easy without Tees or additional manifolds. Manifold mount design uses an O-Ring face seal for simple bolt down installation. Unique center hole mounting and thrust bushing make this device ideal for quick setup T-slot mounting. Chromed and hardened steel blade grips the part while the unique design angle provides both horizontal and vertical clamp force. Three G 1/8 fluid ports on standard model and O-Ring bolt down face seal on the manifold model simplify leak-free installation. BHC™(Black Hard Coating) on the cylinder bodies helps prevent scoring and scratching. Specially designed springs run longer and require less maintenance. Pivot locator/thrust bushing provided. Proprietary seal designs reduce leakage for long lasting cylinders.
E-7
F
ILMV153101 REV B
Specifications
Clamp Capacity* (kN)
Body Size (mm)
Minimum Length (mm)
Piston Area (cm 2 )
Horizontal Stroke (mm)
Model No.
Oil Capacity (cm 3 )
Type
Horizontal Vertical Single Acting (S/A) Cylinders, actuated hydraulically 1 direction, spring returned.
41-5310-01 Standard 41-5310-00 Manifold
8.9 8.9
2.2 2.2
5 5
41 x 73
73 63
2.9 2.9
1.4 1.4
41 x 63.5
* Cylinder capacities are listed at 350 bar (35 MPa) maximum operating pressure. The output force is adjustable by varying hydraulic system pressure. To determine output force, use the following formula: Effective Piston area times Input Pressure = Angular Clamping Force. (Vertical Force= 0.2 x Angular Force) and (Horizontal Force =0.9 x Angular Force) Actual force may vary slightly due to frictional losses, seal drag and/or return springs.
G 1/8 Extend port- 3 places 2 Plugs are supplied to plug the unused ports. (May be used to connect to another device)
.81 wide serrations
23.2
25.5
23.2
15
25.5
Extend Port (Face Seal provided)
13.5 typ
6
39 63.5
6
Locating hole
6.5 2.5
(For blade dimensions see 41-5310-01)
47.5
6.5 4.5 deep)
5 Stroke
16.5
2.5
73
Removable pivot ( 16 .025 x 6 Extension)
Mounting holes for M6 cap screws (cap screws not included)
For proper sealing, the mating surface must be flat within 0.08 mm with a maximum surface roughness of 1.6 µm R a
39
Mounting hole for M8 cap screw (screw not provided) 11 Nm maximum torque
28.6 41
20.5
16
41
6.5
20.5
Mounting hole for M8 cap screw (Screw not included) 11 Nm maximum torque 41-5310-00 Manifold mount model
12.5
11
2.5 typ
41-5310-01 G1/8 Ported model
ILMV153100 REV D
© Vektek December 2021
Inside US 1-800-992-0236
www.vektek.com
Made with FlippingBook - Online catalogs