Planning
Fixture Documentation Worksheet
VektorFlo ® Hydraulic Fixture Setup Documentation and Troubleshooting Worksheet
A-7
Fixture Designed By: __________________________________ Fixture Built By: ______________________________________ Built For: __________________________________________ Fixture Serial # ______________________________________
1. All pressure gauge readings checked and verified at "0" operating pressure. ______ Yes ______ No 2. Main system operating pressure read from the gauge mounted on the clamping system pump ______ bar (MPa) or inlet air pressure from air gauge
on boosters ______ bar (MPa), booster ratio ______:______. 3. Pump restart pressure checked. Pump restarts at ______ bar (MPa). 4. Fixture operating pressure read at fixture gauge ______bar (MPa), side A and ______bar (MPa), side B 5. Pressure limit circuits pressure checked: Side A ______ bar (MPa) Components & location: ______________________________________ Side A ______ bar (MPa) Components & location: ______________________________________ Side A ______ bar (MPa) Components & location: ______________________________________ Side B ______ bar (MPa) Components & location: ______________________________________ Side B ______ bar (MPa) Components & location: ______________________________________ Side B ______ bar (MPa) Components & location: ______________________________________ 6. Sequence operations set to: Side A ______ bar (MPa) Components & location: ______________________________________ Side A ______ bar (MPa) Components & location: ______________________________________ Side A ______ bar (MPa) Components & location: ______________________________________ Side B ______ bar (MPa) Components & location: ______________________________________ Side B ______ bar (MPa) Components & location: ______________________________________ Side B ______ bar (MPa) Components & location: ______________________________________ 7. Fittings checked, secure, no leaks, proper type, not restrictive. ______ Yes ______ No 8. Schematic diagram attached. 9. Bill of materials (hydraulic components) attached.
For troubleshooting assistance contact your Designer/Builder or complete steps 1-9 above and fax this sheet with all additional pages to 1-816-364-0471. We are pleased to be of service.
© 1996-2019 Vektek, This documentation sheet may be used to document fixtures built using VektorFlo ® brand hydraulic clamps. This sheet is copyrighted material and remains the sole property of Vektek. The use of this documentation sheet in its original form or altered state to document fixtures with non-Vektek product is a violation of your assigned rights .
www.vektek.com
Outside US+1-913-365-1045
© Vektek December 2021
Made with FlippingBook - Online catalogs