TuffCam ™ Swing Clamps and Arms
Features
Clamp Time and Fluid Flow Rates for TuffCam ™ Swing Clamps high-speed, precise positioning and/or heavy arm applications. These tri-cam design clamps can position and clamp in less than one second and handle larger arms than VersaCam ™ Swing Clamps. One of the keys to this innovation is the patented Cam Follower Ball Seat that was developed to improve strength and wear. Using the patented Vektek V-Groove technology, a Tungsten Carbide ball for strength and wear, and an elastomer spring, these clamps have reduced static friction for improved clamp breakaway and reduced dynamic friction for improved life. Available in these body styles: - Top Flange - Top Flange Long Stroke - Bottom Flange - Bottom Flange Long Stroke - Low Profile Top Flange - Low Profile Bottom Flange - Low Profile Rod Position Sensing - Low Profile Magnetic Position Sensing Available as single or double acting clamps. The TuffCam ™ design includes three cams for more accurate arm positioning, smoother rotation and lower per cam surface contact pressure. BHC ™ (Black Hard Coating) on the cylinder bodies helps prevent scoring and scratching. Arm clocking feature uses standard Vektek arms. Same mounting envelope as Standard VektorFlo ® Swing Clamps. TuffCam ™ Swing Clamp TuffCam™ Swing Clamps were developed to meet your demand for
C-2
U.S. Patent Nos. 6,886,820 7,032,897
Standard Arm
Extended Arm
TuffCam ™ Swing Clamp Capacity (kN)
Maximum Permissible Flow Rate (cm 3 /min)
Fastest Allowable Clamp Time (sec.)
Maximum Permissible Flow Rate (cm 3 /min)
Fastest Allowable Clamp Time (sec.)
TUNGSTEN CARBIDE CAM FOLLOWER BALL
ELASTOMER SPRING COMPOSITE BALL SEAT
2 5
0.2 0.3 0.4
276 764
0.5 0.7 0.8
110 327 893
DETAIL A
11
1785
ILMV414209 REV B
SEE DETAIL A
Low Profile TuffCam ™
22 33
0.5 0.5
2544 4116
1.0 1.0
1272
- Three cams for more accurate arm positioning, smoother rotation and lower per cam surface contact pressure. - Composite ball seat for improved rotary function, cam follower contact and reduced friction. - Ball material tungsten carbide, one of the world's hardest materials.
2058 ILMV150203 REV E
The above flows are maximum recommendations and clamp times are minimum recommendations. - For upreach and double arms, use extended arm flows and times. - When using custom arms the extended arm flows and times are to be considered the limiting factor. - The actual time to position the clamp will vary by custom arm configuration and may require customer testing in specific application to establish limits.
END USER MUST ADD TAPPED HOLE TO ARM IN PROPER LOCATION/ORIENTATION FOR THEIR APPLICATION.
CLAMPED POSITION
RIGHT SWING TO CLAMP
LEFT SWING TO CLAMP
4 .12
SUGGESTED LOCATION OF DRILL & TAPPED HOLE
BOTTOM FLANGE AND TOP FLANGE MODELS
NOTE: Arm Length and Pressure
6X ARM CLOCKING FEATURE
Limitation Graphs in the end of this section.
ILMV414207 REV F
TuffCam™ Swing Clamp Arm Clocking Feature Arm clocking features shown in the clamped position Six Arm Clocking features equally spaced 60 ˚ apart
www.vektek.com
Outside US+1-913-365-1045
© Vektek December 2021
Made with FlippingBook - Online catalogs