TuffCam ™ Swing Clamps and Arms
TuffCam ™ Low Profile Clocking
TuffCam™ Low Profile Clocking Feature We have added 3 clocking features to Vektek’s Low Profile Swing Clamps. Customers have requested the clocking features to help improve and speed-up arm changes. A drill point on each clamp standardizes arm location at a particular position. An additional 2 (two) orientation drill points reside 120° out from that position and each other. Access to the positioning feature is through the back or side of the arm, making modification a snap for users. Each arm position can have its own specification.
CLAMP POSITION
30º
45º
60º
C-12
90º
Vektek Swing
Restrictors Page C-29
Set Screw
End user must add tapped hole to arm in proper location/orientation for their application.
Reference this dimension according to your arm selection.
10.67 0.127 From Arm Crossbolt Location
Clamped Position
Straight Pull
90 Right Swing To Clamp
90 Left Swing To Clamp
Suggested location of drilled & tapped hole in the arm using a single acting assembly. Shown with standard arm.
2x 120
2x 120
3x Clocking Features Shown At Clamped Position
3x Clocking Features Shown At Clamped Position
ILMV140024 REV D
TuffCam™ Low Profile Swing Clamp Arm Clocking Feature Views shown apply to Double and Single Acting TuffCam ™ Top and Bottom Flange models. Three counter sunk Ø 4.8 x 90° clocking feature drill points are shown in the clamped position. The three clocking features are equally spaced 120° apart.
Clamp Time and Fluid Flow Rates for TuffCam™ Swing Clamps
The flows listed are maximum recommendations and clamp times are minimum recommendations. - For upreach, and double arms, use extended arm time and flow. - When using custom arms, the extended arm flows and times are to be considered the limiting factor. However, the actual time in which the clamp can be positioned will vary by custom arm configuration and may require customer testing in specific application to establish limits.
Standard Arm
Extended Arm
TuffCam ™ Swing Clamp Capacity (kN)
Fastest Allowable Clamp Time (sec)
Maximum Permissible Flow Rate (cm 3 /min)
Fastest Allowable Clamp Time (sec)
Maximum Permissible Flow Rate (cm 3 /min)
2 5
0.2 0.3 0.4
276 764
0.5 0.7 0.8
110 327 893
11
1785
Low Profile TuffCam ™
22 33
0.5 0.5
2544 4116
1.0 1.0
1272
2058 ILMV150203 REV E NOTE: Arm Length and Pressure Limitation Graphs in the end of this section.
www.vektek.com
Outside US+1-913-365-1045
© Vektek December 2021
Made with FlippingBook - Online catalogs