VersaCam™ Swing Clamps and Arms
VersaCam Clocking and Swing Restrictors
Clocking Machined on most Vektek swing clamps, the Arm Clocking feature will dramatically reduce the time it takes to change arms for maintenance, replacement or design setup. This innovation eliminates the need for expensive special swing clamps and moves cost effective user modifications to the clamp arms. Another customer request fulfilled by Vektek... A drill point on each clamp standardizes arm location at a particular position. An additional 3 (three) orientation drill points reside 90° out from that position and each other. Access to the positioning feature is through the back or side of the arm, making modification a snap for users. Each arm position can have its own specification.
C-29
END USER MUST ADD TAPPED HOLE TO ARM IN PROPER LOCATION/ORIENTATION FOR THEIR APPLICATION.
CLAMPED POSITION
STRAIGHT PULL
4±0.12
90° RIGHT SWING TO CLAMP
90° LEFT SWING TO CLAMP
SUGGESTED LOCATION OF DRILLED & TAPPED HOLE
THREADED BODY MODEL
4X CLOCKING FEATURE
45
45
TOP FLANGE AND BOTTOM FLANGE MODEL Standard Swing Clamp Arm Clocking Feature Drill points shown in the clamped position Four clocking features equally spaced 45° apart.
ILMV150110 REV G
Swing Clamp Restrictors Swing Restrictors add just one more element of flexibility when using Vektek Swing Clamps. Normally shipped with the swing angle set to 90˚, you can have swing restrictors added to your clamps to limit the arm swing to 30˚, 45˚ or 60˚of rotation. Restrictors that are factory installed on new product will be specially marked to avoid intermingling clamps with varying swing angles in your shop. Contact your Vektek Customer Service specialist should you need swing angles greater than 90˚.
Swing Clamp Swing Restrictors
Clamp Capacity
Swing Restriction
Model No
81-5505-30 81-5505-45 81-5505-60 81-5509-30 81-5509-45 81-5509-60 81-5513-30 81-5513-45 81-5513-60 81-5518-30 81-5518-45 81-5518-60 81-5519-30 81-5519-45 81-5519-60 81-5522-30 81-5522-45 81-5522-60
2 kN 2 kN 2 kN
30˚ 45˚ 60˚ 30˚ 45˚ 60˚ 30˚ 45˚ 60˚ 30˚ 45˚ 60˚ 30˚ 45˚ 60˚ 30˚ 45˚
4.9 kN 4.9 kN 4.9 kN
11.6 kN 11.6 kN 11.6 kN
CLAMP POSITION
30º
22 kN 22 kN 22 kN
45º
60º
TC LP SC, 22 kN TC LP SC, 22 kN TC LP SC, 22 kN TC LP SC, 33 kN TC LP SC, 33 kN TC LP SC, 33 kN
90º
Vektek Swing Restrictors
60˚ ILMV150112 REV B
© Vektek December 2021
Inside US 1-800-992-0236
www.vektek.com
Made with FlippingBook - Online catalogs