Power Supplies
Boosters, Compact Air/Hydraulic
For Single Acting Systems Multiplies your shop air line pressure to power simple hydraulic systems without electricity. Intensification ratios ranging from 11:1 to 54:1. Output capacities from 2.1 to 9.6 cu. inches. A five port, two-position valve is recommended to provide double acting control of the air piston. Placing the pump over the system will naturally bleed air from the hydraulic circuit. Air/hydraulic boosters are an inexpensive way to power one single acting system. Whether this is your first system or you want a compact “ride-along” power supply for a system, these boosters are an efficient choice. Solid end and intermediate plates capture a reinforced epoxy case which acts as the air cylinder and fluid reservoir. The hydraulic piston runs in a steel cylinder immersed in the fluid reservoir. The double acting air piston design assures you of full fluid capacity on each actuation of the booster.
125
100
75
50
25
J-2
ILS550100 REV F
0
Intensification Ratio
Useable Oil Volume
Maximum Air Input
Model No.
Hydraulic Pressure Out (psi)
Air Over Hydraulic Pressure Intensifiers 55-0184-00 11:1
55-0184-00 55-0104-00 55-0114-02 55-0114-04
9.6 cu. in. 5.0 cu. in. 2.8 cu. in. 2.1 cu. in.
55-0104-00 55-0114-02 55-0114-04
22:1 40:1 54:1
125 psi
ILS550101 REV B
Boosters Dimensions
Control Kit Mounting Holes
Oil Reservoir Fill Port SAE 4 Pressure Port
6.98
12.52
NOTE: One booster can be used to operate one single acting system. Boosters
are not intended for use with single acting palletized (disconnected) systems. Boosters may be mounted horizontally or vertically. If mounted vertically, the oil discharge end
6.99
1/8 NPT Air Inlet Port
1/8 NPT Return Air Port
4.50 2.00
2X 1/4-20 UNC .50
9.59 With Mounting Plates Reversed
4X .28
must point up for proper operation.
55-0184-00 55-0104-00 55-0114-02 55-0114-04
13.34 12.59 11.09
ILS550102 REV E
www.vektek.com
800-992-0236
© Vektek, January 2023
Made with FlippingBook - Online magazine maker