Work Supports / Fluid Advance
High Capacity 3 Bolt Base & Cartridge, 4000 lb. Legacy
Upgrade your 3 bolt base models with higher capacity cartridges!
Normally retracted plungers do not interfere with part loading. Advance them with hydraulic pressure, exerting only spring force to bring the plunger into contact with your part. Hydraulic pressure then automatically sequences,
B-7
“freezing” the plunger properly against the part. Available in 2000 or 4000 lb. capacity. Used units are fully factory refurbishable to like new condition if the support body is undamaged. Order with base or cartridge only. Ventless configuration and built in wipers protect the plunger movement from chips and debris. Up to 3.5X capacity of competitor’s version. Uses Vektek’s BHC technology to guard against corrosion. n O-Ring face seal design makes machining cavities easier. Standard SAE porting and alternate O-Ring manifold face seal is located in the base of the support for bolt down installation. The base can be removed for direct cartridge mounting.
Available as complete assembly too!
ILS100729 REV D U.S. PATENT NO. 10,799,992
Direct Replacement for Older Model
Support Capacity (lbs.)*
Contact Force (lbs.)
Base Dimensions (in.)
Retracted Height (in.)
Model No.
Mounting Style***
Stroke (in.)
Oil Capacity** (cu. in.)
Fluid Advance Work Supports, hydraulic pressure pushes a spring which lifts plunger, hydraulic pressure locks in place. 10-0706-10 10-0706-04 2000 Cartridge 1-6 0.25 N/A 2.14 10-0806-10 10-0806-05 SAE/Manifold 0.90 X 1.31 X 1.75 2.51
0.05
10-0706-16 10-0706-14 10-0806-16 10-0806-15 10-0708-10 10-0708-07 10-0808-10 10-0808-07 10-0708-16 10-0708-17 10-0808-16 10-0808-17
Cartridge
N/A
2.64
0.50
0.07
SAE/Manifold
0.90 X 1.31 X 1.75 3.01
Cartridge
N/A
2.85
0.25
0.20
SAE/Manifold
1.25 X 1.50 X 2.31 3.25
4000
3-10
Cartridge
N/A
3.35
0.50
0.23
SAE/Manifold
1.25 X 1.50 X 2.31 3.75
* Support capacities are listed at 5,000 psi maximum pressure. Support capacities for other pressures are shown in the fluid advance High Capacity and Part Present Sensing load capacity chart. ** Restrict flow rate to a maximum of 130 cu. in./minute. *** For cartridge mount models, see cavity dimensions drawings in this catalog section. **** For complete dimensions, see previous page.
NOTE: The maximum system backpressure a fluid advance work support can overcome is 10 psi. Returning backpressure greater than 10 psi may cause slow or failed retraction.
© Vektek, January 2023
800-992-0236
www.vektek.com
Made with FlippingBook - Online magazine maker