7 MPa Work Support and Clamp Systems
Clamps and Work Supports as a System n Link Clamps, Swing Clamps and Work Supports are designed to work as a system. n Clamps and Work Supports work together at the same pressure. n Sequencing is required and must occur above 2.5 MPa. n Clamps do not need pressure reduction
B-15
when clamping over a work support and operating in the range of 4 to 7 MPa. This applies even when Vektek extended arms are used.
Off the shelf Swing Clamp arms and Link Clamp levers designed to the correct length for clamping over work support centerline.
Swing Clamp arms can be found at the start of Section D and Link Clamp Levers at the start of Section F.
Clamping Over Work Supports, Paired for your Convenience
Swing or Link Clamps Paired with the Right Work Support Clamping Force (kN) Swing Clamp Models Bore Size (mm) Link Clamp Models Work Support Models
Work Support Capacity (kN)
0.9 - 1.7 1.6 - 3.2 2.6 - 5.1 4.3 - 7.6 6.9 -12.6
L1-4X25-00 L1-4X32-00 L1-4X40-00 L1-4X50-00 L1-4X63-00
25 32 40 50 63
L1-6025-00 L1-6032-00 L1-6040-00 L1-6050-00 L1-6063-00
L1-0X12-00 L1-0X15-00 L1-0X16-00 L1-0X20-00 L1-0X22-00
4.0 5.5
10.0 16.0 26.0
Pairs deliver at least 1.5 to 1 Work Support to Clamp Capacity Ratio
WARNING: Operating Work Supports above 7 MPa may damage the work support and will void warranty.
© Vektek February 2021
1-800-992-0236
www.vektek.com
Made with FlippingBook - professional solution for displaying marketing and sales documents online