7 MPa Valves
Pressure Reducing Valve
Pressure Reducing Valve for Circuit Pressure Control For use in double or single acting systems. Direct acting, poppet style, adjustable, cartridge construction. Cartridge can be installed directly into your manifold. Set Range from 1 MPa (10 bar) to 6.2 MPa (62 bar) recommended.
Repeatability is +/- 10% of set pressure. Maximum inlet pressure 20 MPa (200 bar). Two-port design eliminates need for third fluid line to drain bypass flow (internal leakage) back to system reservoir. Recommended filtration: 25 Micron (Nom) / 40 Micron (ABS) (min.) Operation: The Pressure Reducing Valve (PRV) is a Normally Open (N/O) pressure control device. The valve remains open and fluid flows freely to downstream devices (from the valve to devices) until the pressure in the valve reaches the pressure (adjustable) set-point. At the set-point pressure, the valve closes, blocking further flow and pressure rise to the downstream devices. If there is a sufficient down-stream pressure loss (from the valve to devices), the PRV will re-open, allowing flow to pass through the valve until the pressure again reaches the valve set-point. The PRV is designed for use in both single acting and double acting systems.
For proper sealing, the mating surface must be flat within 0.08 mm with a maximum surface roughness of 1.6 µm R a NOTE: Maximum system flow rate is 5.7 l/m, unless otherwise noted. Excess flow voids warranty. Pressure Reducing Valve (PRV) Model No. L7-0512-00 Description Assembly Set Pressure Range 1.0 MPa (10 bar) to 6.2 MPa (62 bar) System Pressure 20 MPa (200 bar) ILML70500
The graphs show the repeat range based on set pressure
The graphs show the pressure drop through a PRV and manifold mount block
0 1 2 3 4 5 6 7 0 1 2 3 4 5 6 7 Set Pressure (MPa)
Pressure Drop vs Flow
0 1 2 3 4 5 6 7
J-7
Filter Plate For above Valves Model No. L7-0842-01 Order a filter plate to protect valve from debris (more details on page K-2)
0
2
4
6
Flow (l/m)
ILML705405 REV A
ILML705406 REV A
28.4 HEX
PRESSURE ADJUSTMENT SCREW
LOCKNUT
162 APPROX.
30.2
31.8
6.4
G1/4 HIGH PRESSURE PORT (INLET)
G1/4 PORT FOR OPTIONAL GAUGE IN REDUCED PRESSURE CIRCUIT
3X 6.7 MOUNTING HOLES
19.6
MANIFOLD MOUNT HIGH PRESSURE PORT (INLET)
6.4
37.1
37.1
38.1
47.6
12.7
15.9
G1/4 REDUCED PRESSURE OUTLET
12.7
MANIFOLD MOUNT REDUCED PRESSURE OUTLET
47.6
31.8
25.9
57.2
COUNTERBORED FOR MANIFOLD MOUNTING 2.29/3.30 FEED HOLES (O-RINGS AND PLUGS PROVIDED)
63.5
7MPa Pressure Reducing Valve Assembly L7-0512-00
ILML70500 REV D
© Vektek February 2021
1-800-992-0236
www.vektek.com
Made with FlippingBook - professional solution for displaying marketing and sales documents online