Megger EVCC300 Electric Vehicle Charger Checker
The new EVCC300 introduces a new and convenient way of checking Electric Vehicle charge points. A simple all in one concept provides an easy to use solution to check both the safety and operation of level 1 and level 2 EV chargers.
· Checks Level 1 and Level 2 Chargers · Checks Chargers with SAE J1772 Type 1 and Type 2 Connectors · Performs Four EV Charger Safety Checks · Performs Four EV Charger Operation Checks
· Checks to See if Nuisance Tripping or GFCI is Likely to Occur · Reads Control Pilot State Response from EV Charger to IEC61852-1 · Fault Checking when Customer Reports Charger Issues to Car Dealership/Service Center
The EVCC300 slowly increases ground / earth leakage current until the protective device trips to ensure it trips at the correct leakage current level. If the leakage current that trips the device is too low it will indicate either an issue with the device or there is already a high level of leakage present.
Shop Megger EVCC300
Each Unit Includea: Continuity/Earth Bond Lead, Blow Moulded Case, VA-T1 Type 2 to Type 1 Connector Adaptor.
5
Transcat.com/megger | 800-233-8918
Make Sure Your Instrument is
Made with FlippingBook Ebook Creator