A Clean Sweep “Clean Sweep” technology automatically pushes machined parts from the machine bed while simultaneously vacuuming sawdust from the spoil board. This saves considerable time and maintains the cleanliness of your manufacturing process. User Friendly Control Control can be used as a touchscreen or with mouse and keyboard. Wireless connectivity, maintenance screens, input/output monitoring, automatic tool height sensor, work and machine coordinate offsets, programming que, and machining graphics are all standard. Automatic Panel Alignment The panel is prepared for processing with automatic alignment cylinders for both side and end alignment. The machine does the work rather than the operator. Parts are pushed against the pop-up locating fences for accurate machining. Multi-zone vacuum table holds parts securely in place. B Pre-Configured for AL-UL Pre-configured for automatic load and unload right from the factory. This is offered as standard on all NewCNC routers. Add the auto load and unload with your initial order or at any time in the future. Machine Motion Machine motion is controlled by servo amplifiers and servo motors at rapid speeds of 3,973 inches per minute. All motion is through planetary gear drives and ball screws (no belts) for precise, crisp, and accurate machining. D E C
16 HP, 21,000 RPM, ISO-30 spindle capable of tools with 3/4” collet. Ten spindle boring block, 32 MM on center, provides line and system hole boring for cabinet and clsoet amnufacturing.
A 12 position “ride-along carousel” enables fast tool change time, and eliminates the back and forth wear and tear of a stationary rack.
10 HP, 250 cubic meter, rotary vane vacuum pumps provide superior part holding in combination with our chamber design vacuum table.
12
Made with FlippingBook Ebook Creator