Operations training
High Voltage Standard / V0 - DRAFT 2025-03-21
6. USING THIS STANDARD TO DEVELOP TRAINING The training in this standard is designed around the GWO taxonomy described in the GWO Requirements for Training. Theoretical and practical activities must be delivered according to the defined taxonomic level to reach the described learning objectives.
In addition to this, all training based on this standard including all related resources shall, as a minimum, meet the requirements described in the GWO Requirements for Training.
6.1 Lesson planning All training developed from this standard must comply with the GWO Requirements for Training and must be supported by the development of comprehensive lesson plans based on and referenced to the standard.
The order in which lessons and elements of each module training are delivered may vary according to the lesson plans prepared for delivering by the training provider.
6.2 Participant Performance Assessment
If a participant fails to meet the demands of a GWO High Voltage module, they shall attend a new module.
High Voltage Operations Participant knowledge, skills and abilities should be assessed on an ongoing basis during practical scenario- based exercises, by means of direct observation and verbal questioning. The instructor should use this as a method of formative evaluation to support participants in reaching the module objectives. The instructor shall also utilise direct observation and verbal questioning on an ongoing basis through the training, to determine participant achievement of the required learning objectives in the domains of knowledge, skills and abilities, to support the overall summative evaluation of the module.
In addition, a written knowledge test shall be administered to each participant to support the overall summative assessment of knowledge-based learning objectives within the module.
High Voltage Cable Pulling Participants knowledge, skills and abilities should be assessed by means of direct observation and verbal questioning during practical scenario-based exercises. The instructor should use this as a method of formative evaluation to support participants in reaching the module objectives.
The instructor must also utilise this direct observation and verbal questioning to determine participant achievement of the knowledge, skills and abilities in support of the summative evaluation of the module.
6.3 Alignment References
Annex 3 contains a table of references to relevant standards and norms that were used to create the GWO High Voltage Standard.
Global Wind Organisation / www.globalwindsafety.org
12 / 114
Made with FlippingBook flipbook maker