Operations training
High Voltage Standard / V0 - DRAFT 2025-03-21
7.4 Duration of the High Voltage Operations Module
The total contact time for completing the High Voltage Operations module is estimated to be 26 hours and 30 minutes.
The training provider must not exceed the time per day given in the table below.
Maximum Duration Per Day
Contact time
8 hours
Total training day
10 hours
Table 7.4.1 - Maximum durations for training days
Contact time includes delivery of course lesson content, practical exercises and activities directly related to these.
Note
The total training day includes contact time, meals and breaks and travel between training sites (where applicable).
7.5 Instructor to Participant Ratio for High Voltage Operations Module
The ratio shown for theory sessions indicates the maximum number of participants per instructor attending the course.
Practical ratios indicate the maximum number of participants to be supervised at any time by an instructor during each practical activity.
Module
Session
Instructor to Participant Ratio
Theory
1:6
High Voltage Operations
Practical
1:3
Table 7.5.1 - Instructor to Participant Ratio for High Voltage Operations Module
7.6 Equipment for the High Voltage Operations Module
The equipment required for training as listed in Annex 1 must be available and must fulfil national legal requirements as listed where applicable.
When teaching about equipment, a generic approach should be applied whenever possible aiming to avoid only a narrow product specific training. This ensures that participants are ready to adapt to the wide range of equipment they will use in the workplace after completion of this training. However, depending on national or regional legislation, company gap analysis and location specific risk assessments, product specific training or familiarisation may be required, which is the responsibility of the duty holder.
Global Wind Organisation / www.globalwindsafety.org
16 / 114
Made with FlippingBook flipbook maker