Operations training
High Voltage Standard / V0 - DRAFT 2025-03-21
8.4 Equipment Requirements of the High Voltage Cable Pulling Module
The equipment required for training as listed in Annex 1 must be available and must fulfil national legal requirements as listed in annex 1 where applicable.
When teaching about equipment, a generic approach should be applied whenever possible aiming to avoid only a narrow product specific training. This ensures that participants are ready to adapt to the wide range of equipment they will use in the workplace after completion of this training. However, depending on national or regional legislation, company gap analysis and location specific risk assessments, product specific training or familiarisation may be required, which is the responsibility of the duty holder.
8.5 Timetable of the High Voltage Cable Pulling Module
The order in which elements of this Module training are delivered may vary according to the lesson plans prepared for delivering by the training provider.
The delivery of this module must comply with the requirements described in the GWO Requirements for Training .
Lesson
Element
Duration
1. Module introduction
1.1
Safety instructions and emergency procedures
1.2
Facilities
1.3
Introduction
1.4
Scope and main learning objectives
1.5
Motivation
1.6
Ongoing assessment
1.7
Human Factors TOTAL
20 min.
Understanding what happens to a cable when it is pulled Different HV cable types, applications, specifications
2. Awareness of basic HV cable theory
2.1
2.2
2.3
Cable construction from core to outer layer
2.4
Awareness of basic electrical field theory
2.5
Awareness of HV cable testing TOTAL
60 min.
3. Breakout inspections
3.1
Breakout inspection key points
3.2
Recognising a good and bad breakout
3.3
Reporting any problems
Global Wind Organisation / www.globalwindsafety.org
70 / 114
Made with FlippingBook flipbook maker