5. Line up your print, then fold the white top and bottom areas of the paper around the edge of the MDF wood and secure it with heat tape to the MDF product.
6. Set the press to 200°C and 330 sec.
7. When the temperature is reached, put the red 2.5mm rubber pad in the press and let it heat up for about 10 min. TIP: You don’t have to change the time on your press from 330 seconds to 10 minutes for this step. What I do is, I let the 330 seconds run out, then quickly open and close my press again, let it run for 330 seconds once more, and repeat for a third time. This process ensures that the pad will be hot enough.
8. When the time is up and the rubber is heated, open the press and, using gloves, immediately lift up the hot red 2.5mm rubber pad. Place the MDF product with the print underneath it. It is VERY IMPORTANT to place the product at the back of your press where there is even and maximum pressure.
Made with FlippingBook - professional solution for displaying marketing and sales documents online