This is an interactive catalogue showcasing all our printing solutions offered to you. Click the links and videos within the catalogue for more information.
Email: techsupport@jgelectronics.com
Tel: 011 789 6033
Web: www.jgelectronics.com How to Youtube Chanel Videos: (5) JG Electronics - YouTube _______________________________________________________________________________________
Instructions for: Metal Inserts, Metal Sheets & Metal lids
All Metal inserts and Metal Sheets:
1. Set the press to 190°C and 90 seconds, medium to high pressure. 2. Remove the plastic protective layer on the product.
3. Print on Sublimation Paper in mirror image, and let the print face the white side/printable side of the metal and secure with heat tape to the metal.
4. Place the product in the heat press with the print on top and then press.
5. Remove print immediately when done.
Metal lids of Tins with no insert
1. First, set the pressure of the press with the lid inside to medium before you switch the press on. After the pressure is correct, set the press to 190 degrees and 90 seconds. 2. Apply the print to the top of the lid and secure it with heat tape. Then press for 90 seconds.
3. After the time is up, remove the print immediately.
To prevent any faded areas on the metal, you can use our black rubber inserts in the lid to keep it from bending while you press. Use the following steps if you decide to use the rubber:
• Press the lid for 50 seconds and 190 degrees to avoid burning the rubber insert. • Remove the lid from the metal box. Place the print face down on the lid and secure it with heat tape. • insert the two black rubber inserts into the lid and place it in the press. • Adjust the pressure to medium-high. It should be nice and firm but not damaging the lid by forcing it down. • Press for 50 seconds.
Page 1 Page 2 Page 3Made with FlippingBook - professional solution for displaying marketing and sales documents online